Section 6: Maintenance; Schedule; Cleaning; Lathe Bed - Grizzly G0632 Owner's Manual

SECTION 6: MAINTENANCE

Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.

Schedule

For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check:
• Loose mounting bolts.
• Damaged centers or faceplate.
• Worn or damaged wires.
• Any other unsafe condition.
Weekly Maintenance:
• Clean off dust buildup.
• Clean and lubricate lathe bed, spindle, and
quill.
Monthly Check:
• Belt tension, damage, or wear.
• Clean out dust buildup from inside belt/pulley
cavity.

Cleaning

Cleaning the Model G0632 is relatively easy.
Vacuum excess wood chips and sawdust, and
wipe off the remaining dust with a dry cloth. If any
resin has built up, use a resin dissolving cleaner
to remove it.
Treat all unpainted cast iron and steel with a non-
staining lubricant after cleaning.
Remove and debris or oily substances from the
inside of the spindle and quill.
-38-

Lathe Bed

Protect the unpainted cast iron lathe bed by wip-
ing it clean after every use—this ensures mois-
ture from wood dust does not remain on the bare
metal surfaces.
Keep your lathe bed rust-free with regular appli-
cations of products like G96
SLIPIT , or Boeshield
® ®

Lubrication

All bearings for the Model G0632 are lubricated
and sealed at the factory, and do not need addi-
tional lubrication.
Wipe a lightly oiled shop rag on the outside of the
headstock spindle. DO NOT allow any oil to get on
the inside mating surfaces of the spindle.
Use the tailstock handwheel to extend the quill
out to the furthest position and apply a thin coat
of white grease to the outside of the quill. DO NOT
allow any oil or grease to get on the inside mating
surfaces of the quill.
Model G0632 (Mfg. 4/12+)
Gun Treatment,
®
T-9.