Connecting A Vcr - Samsung LN-T1953H Owner's Instructions Manual

Connecting a VCR
Video Connecion
These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the
instructions on pages 6-7). Skip step 1 if you have not yet connected to an antenna or a cable system.
1. Unplug the cable or antenna
from the back of the TV.
2. Connect the cable or antenna
to the ANT IN terminal on the
back of the VCR.
Connect an RF Cable between
theANT OUT terminal on the
VCR and the ANT 1 tN (AIR) or
ANT 2 IN (CABLE) terminal on
the TV.
Connect a Video Cable
betweenthe VIDEO OUTjack
on the VCR and the AV IN 1 (or
AV IN 2) [VIDEO] jack on the
TV.
Connect Audio Cables
between the AUDIO OUT
jacks on the VCR and the
AV IN 1 (orAV IN 2)
[R-AUDIO-L] jacks on the TV.
If you have a "mono"
(non-stereo) VCR, use a
Y-connector (not supplied)
to hook up to the right
and left audio input jacks
of the TV. If your VCR
is stereo, you must
connect two cables.
TV Rear Panel
VCR Rear Panel _ _ .......
iS;Audio Cable Not supplied
_1 141 Video Cable Not supplied
RF Cab e (Not supped)
Follow the instructions in "Viewing a VCR or Camcorder Tape" to view your VCR tape.
> Each VCR has a different back panel configuration.
> When connecting a VCR_ match the color of the connection terminal to the cable.
S-Video Connecion
Your Samsung TV can be connected to an S-Video signal from an VCR.
(This connection delivers a better picture as compared to a standard VCR)
1. To begin, follow steps 1-3
in the previous section to
connect the antenna or
cable to your VCR and
your TV.
2. Connect an S-Video Cable
between the S-VtDEO OUT
jack on the VCR and the
AV tN1 [S-VIDEO] jack on
the TV.
Connect Audio Cables
between the AUDIO OUT
jacks on the VCR and the
AV tN1 [R-AUDIO-L] jacks
on the TV.
VCR Rear Panel
TV Rear Panel
Audio Cable (Not supplied)
2 S-Video Cable (Not supplied)
1} RF Cable (Not supplied}
An S-Video cable may be includedwith a VCR. (If not, check your localelectronicsstore.)
>_ Each VCR has a different back panel configuration.
When connecting a VCR, match the color of the connection terminal to the cable.