Ejecting The Cd/Dvd Tray; Adjusting The Print Position - Epson Stylus Photo RX640 series Basic Operation Manual

Ejecting the CD/DVD Tray

1. Make sure that printing is finished.
2. Eject the CD/DVD tray by pulling it straight out
of the front tray.
3. Move the tray lever up to reposition the front tray.

Adjusting the Print Position

If your printed image is not centered on the CD/DVD,
you can adjust its printing position.
1. If necessary, print a test sample using an extra
CD/DVD.
2. Press the q Setup button.
3. Use the u or d button to select the print position
options.
Inner/Outer Print Position
1. Inner
2. Outer
Options Description
CD/DVD Select to resize the print position for the
Inner Print inside diameter of the CD/DVD label. You
Position can adjust it by 1 mm from 18 to 46 mm.
CD/DVD Select to resize the print position for the
Outer Print outside diameter of the CD/DVD label.
Position You can adjust it by 1 mm from 114 to
120 mm.
Up-Down/Left-Right Print Position
1. Move the CD/DVD up
2. Move the CD/DVD right
3. Move the CD/DVD down
4. Move the CD/DVD left
Options Description
CD/DVD Select to finely adjust the CD/DVD print
Print Pos. position. You can adjust it by 0.1 mm from
Up-Down -2 to +2 mm up and down.
CD/DVD Select to finely adjust the CD/DVD print
Print Pos. position. You can adjust it by 0.1 mm from
Left-Right -2 to +2 mm left and right.
4. Press the r button and then use the u, d, l, or r
buttons to select how far (in millimetres) to move
the print position.
5. Press OK to apply the new setting.
Note:
The EPSON STYLUS PHOTO RX retains your settings even
after it has been turned off, so you do not need to readjust the
printing position each time you print a CD/DVD.
Handling a CD/DVD
7