Viewing Wireless Settings - Dymo LabelManager® Wireless PnP User Manual

Click Next.
5
When the wireless setup is complete, click one of the following:
6
• Yes, download and install now to close the tool and download and install
DYMO Label software now.
• No, close to close the tool and install DYMO Label software at a later time.
You cannot use the label maker as a wireless network printer while the label
maker is connected to a USB port on your computer.
Disconnect the label maker from your computer.
7
See Disconnecting the Label Maker from Your Computer on page 7.
Place the label maker in an easily accessible location.
8
Plug the USB cable into the wall adapter and then plug the wall adapter into a
9
wall outlet.
If necessary, press the power button to turn the printer on.
10

Viewing Wireless Settings

You can view the label maker wireless settings from within the built-in software.
To view the wireless settings
Plug one end of the USB cable into the USB port on the back of the label
1
maker.
Plug the other end of the USB cable into an available USB port on your
2
computer.
If necessary, press the power button to turn on the label maker.
3
Start the built-in software.
4
See Starting the Built-In Software on page 10.
Click on the software toolbar.
5
The Wireless Setup tool starts.
Click Advanced.
6
The current wireless settings for the label maker are displayed.
®
15 LabelManager Wireless PnP
User Guide