Dish Network D52W20BYX1 User Manual page 35

Setup Menu
Your monitor's picture tubes might have been disturbed during delivery or
after you moved the monitor, causing the color in your monitor to be out of
alignment. The colors adjust by starting auto convergence.
Note: To converge the monitor's DishDVI picture, you must have the
monitor switched to the DishDVI input during convergence, To converge on
standard definition inputs, repeat auto convergence on one of those inputs.
1, Press MENU and select Convergence.
2, Select Auto Convergence,
3, When the auto convergence is complete, the Red Center Convergence
screen appears, The cross in the middle of the screen should be
completely yellow, If it is not, use the ARROW buttons to move the red
cross to overlap the green cross. Press SELECT/OK when the cross is
completely yellow.
4, The Blue Center Convergence screen appears with a completely cyan
(blue-green) cross in the middle of the screen. If it is not, use the
ARROW buttons to move the blue cross to overlap the green cross.
Press $ELECT/OK when the cross is completely cyan (the monitor
tunes to the last available channel in the channel list),
Manual Convergence
Manual convergence let you adjust the monitor's tubes to make a clear
picture on the screen, For best results, make sure the monitor has been on
for about an hour when you perform the manual convergence procedure.
Note: This type of Convergence is available only on some models,
1, Press MENU and select Convergence.
2_
Either: Select Red Convergence.
The cross in the middle of the screen
should be completely yellow, If it is not, use the ARROW buttons to
move the red cross to overlap the green cross, Press SELECT/OK when
the cross is completely yellow,
Or: Select Blue Convergence, The cross in the middle of the screen
should be completely cyan (blue-green), If it is not, use the ARROW
buttons to move the blue cross to overlap the green cross, Press
$ELECT/OK when the cross is completely cyan,