Dish Network D52W20BYX1 User Manual
Dish Network D52W20BYX1 User Manual

Dish Network D52W20BYX1 User Manual

Hd monitor

Advertisement

Quick Links

Advertisement

Table of Contents
loading

Summary of Contents for Dish Network D52W20BYX1

  • Page 2 Technologies Corporation, 94 Inverness Ibrrace Ea,_, Englewood, Colorado 80112. Part Number: 123564. Printed in the United States of America. DISH Network is a registered _rademark of EchoStar Communications Corporation. information about DISH Network, please visit our website at ww_dishnetworlceom. Manufactured...
  • Page 3: Table Of Contents

    Contents Safety Instructions ............... Chapter 1 - Introduction .............. Key Features ..................How to Use This Guide ..............If You Run Into Problems ..............Chapter 2 - Monitor Description ..........Monitor Front Panel ................Monitor Back Panel ................Using the Remote Control ..............Chapter 3 - Using the Monitor's Features...
  • Page 4 Notes...
  • Page 5: Safety Instructions

    Safety Instructions Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. Do nol install near any heat sources such as radialors, heat registers, stoves, or other apparatus...
  • Page 6 Note to HDTV monitor installer: This reminder is provided to call the satellite TV system installer's attention to Article 820-40 of the National Electrical Code (NEC) that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building...
  • Page 7: Introduction

    HD programming. Unified Remote Control The remote control provided with your DishDVI-equipped DISH Network receiver seamlessly controls your both DISH Network HDTV monitor satellite receiver. To program the remote to control other devices, see the satellite TV receiver User's Guide.
  • Page 8 Introduction Notes...
  • Page 9: Chapter 2 Monitor Description

    CHANNEL CONTROLS to move through the menus and adjust menu controls. Note: Normally, you would want to change programming channels using the DISH Network satellite receiver and its Electronic Program Guide. VOL _ VOL • Volume Controls Turns the volume up or down.
  • Page 10: Monitor Back Panel

    Note: Do not try to use the S-VIDEO and VIDEOIN al the same time because the two signals interfere with each other. Monitor Back Panel DishDVI Input Connect a DishDVI-equipped DISH Network HD receiver. For information on how to display video from this input, see page 8. DIsHDVI - Provides a high-quality digital video interface.
  • Page 11 Monitor Back Panel Component Inputs ¥ L/MONO Connect a component video source, such as a DVD player, to CMP1 or CMP2, For information on how to display video from this input, see page 8, pa LI_o.o R 7 COMPONENT INPUTS (Component Video) - Provides Y-PB-PR...
  • Page 12: Using The Remote Control

    Monitor Description SUBWOOFER Provides non-amplified lower bass audio signals to a subwoofer. Note: If you have connected a subwoofer, make sure you set the Subwoofer option in the Sound Menu to External. See page 14 for instructions. External Speakers (Optional) RIGHT and LEFT EXTERNAL SPEAKERS - Provides amplified...
  • Page 13 See the User's Guide that came with your DISH Network salellite receiver for instructions on using the mode buttons to program remote to control other devices.
  • Page 14 Monitor Description PowerButtons POWER Press the POWER or TV POWER button to turn the monitor ON or OFF, The TV POWER button will also turn the monitor ON or OFF in other remote control modes. _i_i!ii_ii_ii!i i_i_!i!i i!i!iii_ilill ¸I ¸iiii_! ¸!!I ¸i!i!iiii_ !iiiii!!_! iii!_...
  • Page 15 Note: For the best viewing experience, you should use the off-air tuner provided in your DishDVI-equipped DISH Network satellite receiver. The satellite receiver's off'air tuner can receive both analog and digital off-air broadcasts, integrates ofl_air programming...
  • Page 16 Monitor Description Select/OK Button Press the SELECT/OK button to: Select the option you highlight in a menu. _i! !ii_i_!_!_i_ii_!_iii!i!i i!ii_!_iii ¸i:i_iii_!iii_!iiii!!_i!iiiiil;ii_i_i!!!ii ¸iii_iiii_ b_bte bbn_bi i_ Freeze the picture when using VID1, VID2, FRNT, or the monitor's off_ air tuner channels. To unfreeze, press any key.
  • Page 17 See page 13 for more details on PIP and POR Note: PIP through the monitor is not supported on DishDVI, CMP 1, and CMP2. However, your DishDVI-equipped DISH Network receiver may have PIP capabilities which will allow PIP on the DishDVI input. See your User's Guide for your satellite receiver.
  • Page 18 Monitor Description Notes...
  • Page 19: Using The Monitor's Features

    Chapter 3 Using the Monitor's Features One-Touch Satellite Viewing Once your HDTV monitor and DISH Network satellite TV receiver are connected with a D_sHDVI cable, press the SAT button and the monitor and satellite receiver will begin displaying satellite programming.
  • Page 20: Main Menu

    Using the Monitor's Features Main Menu When you press lhe MENU button on the remote control, the Main Menu displays, Use the Main Menu to get to the menus described below which allow you to customize setlings on your monitor, Sound Menu The Sound menu...
  • Page 21 SAP is also used to broadcast a program's audio with descriptions of the video for the visually impaired. Note: Your DISH Network satellite receiver includes secondary audio capabilities, See the User's Guide that came with your salellite receiver...
  • Page 22 Using the Monitor's Features Automatic Sound Level Press the LEFT and RIGHT ARROWS to activate automatic volume control which reduces the annoying blasts in volume during commercial breaks, and also amplifies softer sounds in program material. This feature _iiii_ili!i_ih_!iiiiii_i_!i!ii!:ii!il ¸_i ¸ii!i:!i ¸ii!i!!ii!ii:iii eliminates the need to constantly...
  • Page 23: Picture Menu

    Picture Menu Picture Menu The Picture menu options apply to the video for the main TV and video input selections, To open the Picture Menu, press MENU and then select Picture. Advanced Picture Settings Press the LEFT and RIGHT ARROWS to select among the following Advance Picture Settings: Contrast Expand - Adjusts...
  • Page 24 Using the Monitor's Features Picture Presets Press the LEFT and RIGHT ARROWS to select one of the preset picture settings: _i!i!i_i_i_i_iiii_hi_i+!!iii!!iii!!; ¸ii!;!i_i!i!i ¸i++!iiii!_i!+!i!i+iiiii ¸ili Movie, Videogame, Personal, Sports, Ideal, Showroom, or Video Camera, Choose the setting that is best for your viewing environment.
  • Page 25: Channel Guide Menu

    Channel Guide Menu Channel Guide Menu The Channel Guide menu allows you to view and select from the entire list of inputs and channels their labels, To open the Channel Guide menu, either press GUIDE or press MENU and then select Channel Guide.
  • Page 26: Parental Control

    MENU and then select Parental Control, Note: Parental Control setlings are not available for D_sHDVI, CMP1, or CMP2 inputs. Your DishDVI-equipped DISH Network satellite TV receiver provides parental controls for the DishDVI inpul. See the User's Guide thai came with...
  • Page 27 Parental Control Rating Description and Content Themes for Age-Based Ratings TV-Y7 Directed to Children 7 Years and Older - Designed for children ages 7 and above. It may be more appropriate for children who have acquired the developmental skills needed to distinguish between make- believe and reality.
  • Page 28 Using the Monitor's Features Either: Press SELECT/OK to toggle between Block and View. Or: Use the ARROW buttons to scroll to an individual Content Theme, Press SELECT/OK to toggle between _ and _, When you block a content theme for a particular rating, you automatically block that contenl...
  • Page 29: Pip Menu

    Note: PIP through the monitor is not supported on DishDVI, CMP 1, and CMP2. However, your DishDVI-equipped DISH Network receiver may have PIP capabilities which will allow PIP on the DishDVI input. See your User's Guide for your salellite receiver.
  • Page 30 Using the Monitor's Features Display Mode i_i_i ¸i _!_iltfii_i!!!i!i!!ii_i!I J_!ii iii!ii!!! i!ii! !_!i_i!iii! i!i!ill ¸i ; Use the LEFT and RIGHT ARROWS to choose the Display Mode: Off - No window is displayed, PIP - The PIP window is displayed. POP - The POP window is displayed, PIP Channel Use the LEFT and RIGHT ARROWS...
  • Page 31: Setup Menu

    Signal Type. Note: For the best viewing experience, you should use the off-air tuner provided in your DishDVI-equipped DISH Network satellite receiver. The salellite receiver's oft_air tuner can receive both analog and digital oft_air broadcasts, will integrate...
  • Page 32 Only specific programs encoded with closed-captioning information are applicable. When a program is closed captioned, CC is displayed in the channel banner. Note: You DISH Network satellite receiver includes closed captioning features. See your User's Guide for details.
  • Page 33 Highlight Setup and press SELECT/OK, Highlight Autotuning and press SELEC TlOK. Choose which channel you would like to set. Note: The mode buttons on your DISH Network remote control correspond to the Autotuning channels as follows: The SAT mode button switches to the input assigned to the Sat/ Cable channel.
  • Page 34 DVI - A DishDVI-equipped DISH Network satellite receiver is connected to the DishDVI input on the back of the monitor and you wanl...
  • Page 35 Setup Menu Your monitor's picture tubes might have been disturbed during delivery or after you moved the monitor, causing the color in your monitor to be out of alignment. The colors adjust by starting auto convergence. Note: To converge the monitor's DishDVI picture, you must have the monitor switched to the DishDVI input during convergence, To converge...
  • Page 36: Input Banner

    Using the Monitor's Features Input Banner There are several indicators that might appear when you press the INFO button on the remote. This display is called the Input Banner. The following _ii_i_i_!_i_iiii!iii_i_!_iiii!ii_ii_iiiiii!!i ¸i!!i!i!i_ii_iiii!;ii_!i!i!i_i_i ¸ii!i_ii!i!_i!_ill list describes the items on the Input Banner screen. Displays the currenl input channel and label assigned to the channel.
  • Page 37: Installation And Setup

    Chapter 4 Installation and Setup Installation Considerations Protect Against Power Surges Connect all components before you plug any of their power cords into the wall outlet. Turn off the monitor and/or component before you connect or disconnect any cables. Make sure all antennas and cables are properly grounded.
  • Page 38: Connecting Your Hdtv Monitor

    Connecting Your HDTV Monitor Use the diagram below and the following instructions to connect your DISH Network HD monitor to your DISH Network satellite receiver and other optional devices. This is the recommended installation for best results, though other installations...
  • Page 39 DishDVI connectors. Connect red and white RCA-type cables between the matching color RCA-type plugs on the monitor audio inputs and DISH Network satellite receiver audio outputs. Connect a VCR (Optional) Follow these instructions to connect the monitor to a VCR. See your VCR User's Guide for VCR selup instructions.
  • Page 40: Setup Instructions

    TVs. If the remote control has been programmed to operate a different TV, you can restore the remote conlrol factory seltings to control your DISH Network HDTV monitor by performing the following: Press and hold the TV button until all four mode buttons light.
  • Page 41: Chapter 5 Troubleshooting

    Chapter 5 Troubleshooting Use these tables if you have problems using the system before calling the Customer Service Center, Many problems arise from misunderstandings how the system works, especially when you are just becoming familiar with it, These tables cover many problems, usually with a simple solution for each one.
  • Page 42: Troubleshooting Tables

    Front Panel Block in ttle Parental Control nl_m and press OK to uncheck the box Can't get lo DISH Network programming • Make sure your monitor is on • Monitor set for the wrong input. Piess tile SAT button on the i_mote control •...
  • Page 43 Cbeck your satellite receiver's User's Guide Closed cap*ion is not working • Closed caption is available only on 480i inputs through the monitor. Check your User's Guide fbr you DISH Network satellite receiver for details Freeze button not working • The fieeze fhature is not available for Conlponent...
  • Page 44 Troubleshooting Notes...
  • Page 45: Appendix

    PARTS: For a period of one (1) year from the original date of purchase, EchoStar determines in its sole judgment that any part of a DISH Network Monitor is defective subject to the limitations of this warranty, EehoStar will...
  • Page 46 TO USE, THIS DISH NETWORK MONITOR. UNDER NO CIRCUMSTANCES SHALL ECHOSTAR'S LIABILITY, tF ANY, EXCEED THE PURCHASE PRICE PAID FOR THIS DISH NETWORK MONITOR. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A...
  • Page 47: Fcc Compliance

    FCC Compliance How State Law Relates to this Warranty Some states do not allow the exclusion nor limitation of incidental consequential damages, or limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you also may have other rights that vary from state to state.
  • Page 48 Notes...
  • Page 49: Index

    Write the following information in the spaces provided below. You may need to provide this information if you call the Customer Service Center. Purchase Location Name: Purchase Location Telephone Number: Monitor Serial Number: This product incorporates copyright protection technology that is protected by U,S. patents and other intellectual property rights.

Table of Contents