Table of Contents
Advertisement
Using the Monitor's
Features
_i i_il ¸ !!i;
;);i:!;
!i!ii!!!
The VCR mode button switches
to the input assigned
to the VCR1
channel,
The AUX mode button switches
to the input assigned to the DVD
channel,
The VCR2 channel
is currently
unused,
5,
Press the RIGHT ARROW
bullon to select the choice that malches
the
way you have the device connected
to the monitor
and press SELECT/
OK.
The choices and brief explanations
follow:
N/A - Choose this if you don't have this particular
device connected
to
the monitor, or if you don't want the monitor to automatically
tune to the
correct channel when you're using this device,
Channel 3 or 4 - The device is connected
to the CABLEIANTENNA jack on
the back of the monitor, and you want the monitor to tune to channel 3
when you press the corresponding
button on the remote. Reminder:
make sure lhe device's
CHANNEL
3/4 switch is set to channel 3,
VID1 or VID2 - The device is connected
to a VIDEOor S-VIDEOjack on
the back of the monitor
and you want the monitor
to tune to a VIDEO
input channel when you press the corresponding
butlon,
FRNT - The device is connected
to the VIDEOjack on the front of the
monitor
and you want the monitor to tune to the front VIDEO input
channel (FRNT) when you press the corresponding
bullon.
CMP1 or CMP2 - The device is connected
to the CMP1 or CMP2
component
jacks on the back of the monitor an you want the monitor to
tune to a component
input channel when you press the corresponding
button,
DVI - A DishDVI-equipped
DISH Network
satellite receiver is
connected
to the DishDVI input on the back of the monitor
and you wanl
the monitor
to tune to the DishDVI channel when you press the
corresponding
button.
Convergence
Auto Convergence
Auto Convergence automatically
adjusts the monitor's
tubes to make a
clear picture on the screen. You should perform auto convergence
when you
install, move or rotate your monitor. For best results, make sure the monitor
has been on for about an hour when you perform the auto-convergence
procedure.
Note: Auto Convergence is available
only on some models.
There are two adjustments
made when you use auto convergence:
Red convergence
displays the Red convergence
screen, allowing
you to use the arrow buttons to align the red and green images.
Blue convergence displays
the Blue convergence
screen, allowing
you to use the arrow buttons to align the blue and green images,
Advertisement
Table of Contents
Troubleshooting
