Dish Network D52W20BYX1 User Manual page 17

Using the Remote Control
PIP Button ,_,P
Press this button to open the Picture-In-Picture (PIP) window. Press the
button a second time to open the Picture-Outside-Picture (POP) window.
When you press the PIP button a third time, the POP window will close.
Press the CANCEL button at any time to close the PIP or POP window.
See page 13 for more details on PIP and POR
Note: PIP through the monitor is not supported on DishDVI, CMP 1, and
CMP2. However, your DishDVI-equipped DISH Network receiver may
have PIP capabilities which will allow PIP on the DishDVI input. See your
User's Guide for your satellite receiver.
Swap Button
Press this button to swap the video in the main display with the video in the
PIP or POP window.
Position Button
Press this button to move the PIP window to different positions on the
monitor screen.
Number Pad Buttons
abe clef
Use the NUMBER
PAD buttons to enter a channel
number to change the channel.
_hi jkl
To enter a one-digit channel, enter a zero first. To
enter a two-digit number, enter the two digits. To pclrs
tuv
enter a three-digit number, press and hold the 1
button until 1-- displays, then add the second and
=,
third digits (for example, to tune to channel 123,
press and hold 1 until 1-- displays, release the 1
button, and then press 2 and 3).
mrlo
@
wxyz
Note: For the best ofl_air viewing experience, you should use the ofl_air
tuner provided in your DishDVI-equipped DISH Network satellite receiver.
The satellite receiver's off-air tuner can receive both analog and digital off.
air broadcasts, integrates off-air programming into its Electronic Program
Guide, and allows all of the satellite and off-air programming to be viewed
over a single high-quality digital connection.