Installation - AEG BE2003021 User Manual

22 www.aeg.com
Steam and condensation
settle on the food and in
the appliance cavity.
The display shows
"12.00".
If you cannot find a solution to the prob-
lem yourself, contact your dealer or the
service centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

12. INSTALLATION

WARNING!
Refer to the Safety chapters.
The built-in unit must meet the
stability requirements of DIN
68930.
The oven is designed to be connected
to 230 - 240V ~ (50Hz) electricity supply.
The oven has an easily accessible termi-
nal block which is marked as follows:
Connection via
Cooker Control
Circuit
It is necessary that you install a double
pole switch between the oven and the
electricity supply (mains), with a mini-
mum gap of 3 mm between the switch
contacts and of a type suitable for the
required load in compliance with the
current regulations.
The switch must not break the yellow
and green earth cable at any point.
Problem
Min. size Cable/
flex
2,5 mm²
Possible cause
You left the dish in the
appliance for too long.
A power cut.
on the front frame of the appliance cavi-
ty.
Letter L - Live terminal
Letter N - Neutral terminal
- Earth terminal
The cable used to connect the oven to
the electrical supply must comply to the
specifications given below.
For UK use only
Cable/flex type
PVC / PVC twin
and earth
Remedy
Do not leave the dishes
in the oven for longer
than 15 - 20 minutes af-
ter the cooking process
ends.
Reset the clock.
.........................................
.........................................
.........................................
CAUTION!
This oven must be earthed!
Fuse
min: 15 A
max: 20 A
After installation and connecting,
the cable must be placed so that
it cannot at any point reach a
temperature of more than 50°C
above the ambient temperature.
Before the oven is connected,
check that the main fuse and the
domestic installation can support
the load; and that the power sup-
ply is properly earthed.