Removing The Transport Support; Rear Spacers - AEG A92860GNX0 User Manual

Green and Yellow:
1
Brown:
3
Blue:
5
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
1. Connect the wire coloured green and yellow to the terminal marked either with the
letter "E" or by the earth symbol
2. Connect the wire coloured blue to the terminal either marked with the letter "N" or
coloured black.
3. Connect the wire coloured brown to the terminal either marked with the "L" or col-
oured red.
4.
Check that no cut, or stray strands of wire is present and the cord clamp
over the outer sheath.
5. Make sure the electricity supply voltage is the same as that indicated on the appliance
rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug fitted
the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.
WARNING!
A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it
is disposed of safely.

Removing the transport support

Your appliance is equipped with transport support to secure the door during transportation.
To remove them do these steps:
1. Open the door.
2. Remove the transport support from the
door sides.
3. Remove the transport support from the
lower hinge (some models).
Some models are fitted with a silencing pad
under the cabinet. Do not remove this pad.

Rear spacers

Install the spacers provided within the accessory bag as shown in the figure.
Earth
Live
Neutral
or coloured green and yellow.
2
. In the event of having to change
3
21
Installation
4
is secure
2