Drying Only And Autodrying - Zanussi ZKI 225 User Manual

Drying only and autodrying

Drying only
The recommended load to dry in your washer-
dryer is 3 kg for cottons and 2 kg for
synthetics.
Note! It is possible also to dry up to 4 kg of
cotton items (see the drying time table).
The water tap must be open and the drain
hose must be positioned in the sink or
connected to the drain pipe.
1. Load the laundry.
2. Turn the selector dial to «Cotton» or
«Synthetics» programme in the «Drying»
sector.
3. Select the duration of the cycle drying by
pressing repeatedly the button
time you want appears on the display (see
the drying times).
Every time you press this button the drying
time increases by 5 mins.
Note! The programme time will automatically
increase by up to 2 minutes. This is quite nor-
mal.
8
4. Press button to start the programme. After
the programme has started, the time remain-
ing is updated every minute.
5. At the end of the programme, the buzzer
sounds. A flashing zero «
the display.
At this point, begins the anti-crease phase
which lasts for about 10 minutes. During this
time the light 9 is alight, the door cannot be
opened and the display keeps showing three
flashing zeros « ».
0
At the end of this phase, the pilot light 9
goes off and the door can be opened.
Attention! if you wish to open the door
before the anti-crease phase or to interrupt
it, press any key or turn the programme
selector dial to any programme position
(NON-STOP programme)
5
until the
» will appear on
0
(except «O»).The door can be opened in a
few minutes.
6. Turn the selector dial to the «O» position to
switch the machine off. Remove the laundry.
Autodrying
For NON-STOP programmes, the
recommended load size is 3 kg for cotton and
2 kg for synthetics. Note! It is possible also
to dry up to 4 kg of cotton items (see the
drying time table).
Do not use a dosing device/ball when carry-
ing out a washing & drying programme.
1. Load the laundry and add detergent and fab-
ric softener.
2. Switch the machine on by turning the selec-
tor dial to the selected wash programme/fab-
ric.
3. Select the drying time by pressing button
The display shows the entire duration of the
washing and the selected drying cycle.
4. Select the required options by means of the
relevant buttons. If possible, do not select a
spin speed lower than that proposed by the
appliance to avoid a too long drying time so
saving energy. In any case the reduction of
the spin speed is only possible after select-
ing drying.
5. Start the programme by pressing button
After the programme has started, thetime
remaining on the display is updatedevery
minute.
6. At the end of the programme the buzzer
sounds. A flashing zero «
display. At this point of the programme, starts
an anti-crease phase which lasts about 10
minutes. During this time the door is locked
and the display keeps showin the flashing
5
.
8
.
» appear on the
0
17