Zanussi ZKI 225 User Manual page 16

selected, the message Err is displayed for a
few seconds and the red light of this button
flashes for 3 times.
Altering an option or a running programme
It is possible to change some option before the
programme carries it out.
Before you make any change, you must pause
the washer-dryer by pressing button
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «O» and then to the new
programme position. Start the new programme
8
by pressing button
The washing water in the tub will not empty
out.
Interrupting a programme
8
Press button to interrupt a programme which
is running, the corresponding light starts to
flash. Press the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «O» to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
When the machine is working and throughout
the delay time the door will be locked. If you
need to open the door, you must first set the
washer-dryer to PAUSE by pressing button
9
If the light goes off the door can be opened.
9
If the light remains lit, this means that the
machine is already heating or that the water
level is too high (do not force the door!).
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «O». After a few
minutes the door can be opened (Pay
attention to the water level and
temperature!).
16
8
.
again.
After this procedure, it will be necessary to set
the programme and the options again and then
to depress button
At the end of the programme
The machine stops automatically. Some
acoustic signals sound and on the display will
appear a flashing «
9
and the light
opened.
If at the end of a programme there is water in
the tub, the light
locked to indicate taht the door must be empty
out.
To empty out the water follow the following
instructions:
1. turn the programme selector dial to «O»
2. select the draining or spinning programme
3. reduce the spin speed, if needed, by
pressing the button
4. press button
5. at the end of programme, the display shows
a flashing zero «
it will be possible to open the door.
At the end of the cycle, turn the programme
selector dial to «O» to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap.
Leave the door open to prevent the formation
of mildew and unpleasant smells.
8.
«Stand by»
If your laundry is not removed within 10 minutes
after the programme is finished, the backlight of
the display switches off and the energy saving
system will be enabled.
Only the button
that the appliance has to be switched off.
By pressing any button the appliance will come
out from the energy saving status and you
could set another washing programme or swich
off the appliance.
8
.
». The light of button
0
go off. The door can be
9
remains on. The door is
2
8
to start the programme
9
», the light goes off and
0
8
pilot light is blinking to indicate
8