Zanussi ZKI 225 User Manual page 26

Table of Contents

Advertisement

4. Unscrew and remove the two large rear
bolts B and the six smaller bolts C.
D
5. Remove the bracket D, refit the six smaller
bolts C and slide out the relevant plastic
spacer E.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs etc.
Before placing it on small tiles, apply a rubber
coating.
Never try to correct any unevenness in the
floor by putting pieces of wood, cardboard or
similar materials under the machine.
If it is impossible to avoid positioning the
machine next to a gas cooker or coal-burning
stove, an insulating panel covered with
aluminium foil on the side facing the cooker or
stove, must be inserted between the two
appliances.
The machine must not be installed in rooms
where the temperature can drop below 0.
The water inlet hose and the drain hose must
not be kinked.
Please ensure that when the appliance is
installed, it is easily accessible for the engineer
26
6. Fill the smaller upper
hole and the two
large ones with the
corresponding
plastic plug caps
supplied in the bag
containing the
instruction booklet.
in the event of a breakdown.
Carefully level by screwing the adjustable feet
in or out.
Never place cardboard, wood or similar
materials under the machine to compensate for
any unevenness in the floor. After having
levelled the machine, tighen the lock nuts.
Water inlet
The inlet hose is already hanged on the rear of
the machine. leaks.
Do not use the hose from your previous
machine to connect to the water supply.
Attention!
Do not place the inlet hose downwards.
Angle the hose to the left or right depending
on the position of your water tap.
will have to purchase a new, longer hose
specially designed for this type of use
1. Set the hose
correctly by
loosening the ring
nut. After positioning
the inlet hose, be
sure to tighten the
ring nut again to
prevent leaks.
2. Connect the hose to
a cold water tap with
a 3/4" thread.
The inlet hose must
not be lengthened. If
it is too short and
you do not wish to
move the tap, you

Advertisement

Table of Contents
loading

Table of Contents