Table of Contents
Advertisement
INSTALLATION STEPS
Anti-tip bracket installation
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
See the installation instructions for details.
Failure to follow these instructions can result in death or
serious burns to children and adults.
Anti-Tip Bracket
Making sure the anti-tip bracket is installed:
__
i Slide range forward.
• Look for the anti-tip bracket securely attached to floor.
Slide range back so rear range foot is under anti-tip bracket.
RangeFoot
NOTICE: Parts supplied are for installation in wood floors.
If mounting in wood is not possible,
consult your local hardware store to purchase anchoring hardware needed to fasten the anchor
bracket to your type of floor. Contact a qualified floor covering installer for the best procedure
for drilling mounting holes through your type floor covering.
Use the anti-tip bracket template!instruction
sheet provided to install the anti-tip bracket.
Anti-tip bracket must
be anchored securely to the sub floor.
Depending on the thickness of your flooring, longer screws may be
needed to anchor the bracket to the sub floor. Longer screws are available from your local hardware store.
Operating
position
Before moving range across floor, check that range is
still on cardboard shipping base to protect floor
covering.
1. Remove cardboard shipping
base from under range. Use
channel lock pliers ,to
unscrew rear leg levelers
approximately
1/2" so that
the rear leg levelers will slide
in under the ancher bracket.
-- leveling legs
2. Carefully move range into
final operating
position.
Check that rear leveling
leg is engaged in anti-tip
bracket.
3. If installing the range in a
mobile home, you MUST secure the range to the floor.
Any method of securing the range is adequate as long
as it conforms to the standards in the "Mobile home
installation" instructions, Page 17.
.
Place rack in oven. Place level on rack, first side to
side; then front to back.
If range is not level, pull range forward until rear level-
ing leg is removed from the anti-tip bracket.
Use channel lock pliers to adjust leveling legs up or
down until range is level. Push range back into posi-
tion, Check that rear leveling leg is engaged in anti-tip
bracket.
Note: Oven must be level for satisfactory baking
conditions.
- 23 -
Advertisement
Table of Contents
