Table of Contents
Advertisement
Anti-Tip
Bracket
Installation
Imons
Important
Safety Warning
To reduce the risk of tipping of the range. the range must be secured to the Hoor
by a properly installed anti-tip bracket and screws packed with the range.
Failure to install the anti-tip bracket could allow the range to accidentally tip
over if excessive weight is placed on an open door or if a child climbs upon it.
Serious injury might result from spilled hot liquids or from the range itself.
Refer to the instructions below for proper installation.
NOTE: If the range is ever moved to a different location. the anti-tip bracket
must also be moved and installed with the range. To check for proper
installation. see step 5.
Anti-Tip
Bracket
Installation
Instructions
Tools Required:
i/~~," Nutdriver or Flat Head Screwdriver
Adjustable Wrench
Electric Drill & '/lb" Dia. Drill Bit
'/lb" Dia. Masonry Drill Bit (if installing in concrete)
Brachet attaches to the floor at the back of the range to hold both rear leg levelers.
When fastening to the floor, be sure that screws do not penetrate electrical
u iring or plumbing. The screw\ provided will work in either wood OI- concrete.
I. Unfold paper template and place it flat on the floor with the back and jidc
edges positioned exactly M,here the back and \ides of range will be located
when installed. (LI\c the diagram belou, to locate bracket if template is not
available.)
2. Mark on the floor the location of the two mounting holes shown on the
template. For easier installation. '/Ic," diameter pilot holes '/?'I deep can be
drilled into the tloor.
3. Remove template and place brnckct on floor with turned up flange to the
front. Line up holes in bracket ulith marks on floor and attach with two screw\
provided. Bracket must be secured to solid floor-. If attaching to concrete
floor. first drill '/IO" dia. pilot holes using a masonry drill bit.
4. Level range if necessary. by adJusting four leg levelers with wrench. (A
minimum clearance of 'ix" is required between the bottom of the range and
the rear leveling feet.)
5. Slide range into place making sure rear leg\ are trapped by ends of bracket.
Range may need to be shifted slightly to one side as it is being pushed back
to allow rear legs to align with bracket. Remove lower pane1 or storage
drawer to inspect bracket or grasp the top rear edge of the range and carefull!
attempt to tilt it forward to make sure range i\ properly anchored.
BACK EDGE OF
RANGE OR
ANT-LAP
WALL
BRACI$ET
LOCATION
SLIDE
BACK
26
Advertisement
Table of Contents
