Electronic Oven Controls; Oven Light; Troubleshooting - Whirlpool WFE710H0AH0 User Instructions

The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
To Replace: 4. Replace bulb, then bulb cover by turning clockwise.
1. Unplug range or disconnect power. 5. Plug in range or reconnect power.
TROUBLESHOOTING
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
www.whirlpool.com
Operation
PROBLEM POSSIBLE CAUSES SOLUTIONS
Nothing will operate Power supply cord is unplugged. Plug into a grounded outlet.
Household fuse is blown or a Replace the fuse or reset the circuit breaker. If the problem
circuit breaker is tripped, continues, call an electrician.
Range is in Sabbath Mode. See "Sabbath Mode" section.
The control knob is set Push in knob before turning to a setting.
incorrectly.
The range is in Demo Mode.
Cooktop will not operate
Demo Mode will deactivate the Warm Zone element. See
"Demo Mode" in the "Electronic Oven Controls" section.
Excessive heat around Cookware that is not the proper Use cookware about the same size as the surface cooking
cookware on cooktop size area, element or surface burner. Cookware should not extend
more than 1/2"(1.3 cm) outside the cooking area.
Cooktop cooking results not Control knob set to incorrect heat See "Cooktop Use" section.
what expected level
Oven will not operate
Range is not level.
The electronic oven control was
set incorrectly.
Delay Start was set.
The oven control lockout is set.
Level the range. See the Installation Instructions.
See "Electronic Oven Controls" section.
See "Cook Time" section.
See the control lock keypad feature in the "Feature Guide"
section.
The range is in Demo Mode. Demo Mode will deactivate all heating elements. See "Demo
Mode" in the "Electronic Oven Controls" section.
Convection fan not working
Oven temperature too high or
too low
Oven door is open.
Oven temperature calibration
needs adjustment
Temperature has been changed
to Fahrenheit or Celsius.
Close oven door. See "Convection Cooking" section.
See "Oven Temperature Control" in the "Electronic Oven
Controls" section.
See "Fahrenheit and Celsius" in the "Electronic Oven Controls"
section.
Oven indicator lights flash Needs service (oven indicator See "Control Display" in the "Electronic Oven Controls"
lights are flashing) section. If the indicator light(s) keeps flashing, call for service.
See cover for contact information.
Display shows messages Power failure (display shows Clear the display. On some models, reset the clock, if needed.
flashing time) See "Clock" keypad feature in the "Feature Guide" section.
Error code (display shows letter
followed by number)
Press the CANCEL keypad to clear the display. See "Control
Display" in the "Electronic Oven Controls" section. If it
reappears, call for service. See cover for contact information.
16