WAGNER QuickTouch power roller Owner's Manual page 7

, Follow these
steps ONLY if you used latex-based material AND you have an available garden hose.
• Make sure you have completed steps 1-4 in Cleanup = Pur_ the Paint Hose before using the Quick-clean TMfeature.
1. Unplug the power cord. Remove the paint can from the
unit, and place the unit on its side with the Quick-clean TM
adapter facing up.
The unit should be placed on its side so material will not
leak from the Quick-clean
TM
adapter when the plug is
removed. Make sure your floors and furnishings are
protected with a drop cloth.
2. Remove the Quick-clean
TM
inlet plug from the Quick-
clean
TM
adapter. Insert a garden hose into the Quick-
clean
TM
adapter. Turn the Quick-clean
TM
adapter fitting
counterclockwise to secure the hose. Make sure the
washer stays inside the fitting (a). Place the unit upright.
(a)
3. Hang the roller arm from an empty five-gallon bucket.
While holding the suction tube over the five-gallon bucket
SLOWLY turn the garden hose ON. Let the water run
through the suction tube and out the roller arm holes until
the hose runs clear. Empty bucket as necessary.
4. Turn the garden hose off. Remove suction tube from five-
gallon bucket and replace the Quick-clean TMinlet plug.
Leave the arm hanging from the bucket.
÷
5. Plug in the power cord. Flip selector switch to CLEAN.
Let unit run until all fluids have been purged from the end
of the paint hose. Turn the unit OFF, and unplug the
power cord. Properly dispose of the cleaning solution.
6. Thoroughly clean the roller cover, core and cap. Press
the quick-release tabs and remove the roller arm from the
handle. Wipe any remaining paint with the appropriate
cleaning solution and a damp cloth (DO NOT
SUBMERGE ROLLER HANDLE!).