Product Registration - WAGNER QuickTouch power roller Owner's Manual

Problem Cause
The pump will not run
1. The power cord is unplugged, or no power in
outlet.
2. The handle button is not being depressed, and the
switch is not set to PAINT.
3. There is a kink in the air hose.
Solution
1. Plug the power cord into 120V outlet.
2. Turn switch to PAINT and depress
handle button.
3. Unkink the air hose
If unit still fails to run, call Customer Service.
Paint fails to load the roller.
1. The suction tube is not immersed in the paint.
2. There is an obstruction in the suction tube.
3. The paint can is empty.
4. The O-rings on the Quick-clean _-Minlet plug are
worn or dirty.
5. The Quick-clean TM plug is missing from the Quick-
clean TM adapter.
1. Fully immerse the suction tube into the
paint.
2. Remove the obstruction.
3. Fill the paint can.
4. Properly clean and lubricate, or replace.
5. Install Quick-clean _-Mplug.
The motor does not turn off.
1. The switch is turned to CLEAN.
2. There is a kink in the air hose.
3. There is an air switch malfunction.
1. Turn switch to OFF.
2. Unkink the air hose.
3. Call Customer Service.
There is paint leakage.
1. The seal on the roller arm is backwards.
2. The seal and cap were not properly cleaned.
3. The O-ring and the connecting area were not
cleaned properly.
4. Paint residue on connecting areas.
5. The O-rings are damaged or missing.
6. The roller cover is worn or damaged.
7. The roller core or cap is worn or damaged.
8. The bearing areas on the roller arm are worn.
9. The pump tube is punctured.
10. The paint hose is damaged.
11. The O-rings on the Quick-clean _M inlet plug are
worn or dirty.
12. The Quick-clean TM plug is missing from the Quick-
clean TM adapter.
1. Turn the seal around.
2. Clean and properly lubricate.
3. Clean and properly lubricate (pg 10).
4. Clean connecting areas.
5. Replace the O-rings*
6. Replace the roller cover*.
7. Replace the roller core or cap*.
8. Call Customer Service
9. Call Customer Service
10. Call Customer Service
11. Properly clean and lubricate, or replace.
12. Install Quick-clean _M plug.
Water leakage from the Quick-
clean _-Minlet fitting during
cleaning.
1. Missing washer.
1. Replace.
* Replacement parts available by calling customer service
Have you tried the recommendations above and are still having problems? in the United States, to speak to a
customer service representative, call our Customer Service at 1-800-760-3844 Monday through Friday between 8:00
AM and 4:30 PM Central time.
Product Registration Card
Send in your product registration card or register online at www.wagnerspraytech.com. Proper registration will serve as proof of
purchase in the event your original receipt becomes misplaced or lost. Returning this card will expedite the processing of your
warranty. Be sure you write your unit's date code on the card before sending it. The date code is located below the specification
label underneath the base of your unit (for example, S087R). The additional information will also help us to develop new products
that best meet your needs and desires.
11