Grounding Instructions - Sharp Carousel R-7A85 Operation And Cooking Manual

Unpacking and Examining Your Oven
Remove:
1. all packing materia{s from inside the oven cavity° Read enclosures and SAVE the
Operation Manual
2 the feature sticker from the outside of the door, if there is one.
Check the oven for any damage, such as misaligned or bent door, damaged door seals
and sealing surfaces, broken or loose door hinges and latches and dents inside the cavity
or on the door If there is any damage, do not operate the oven and contact your dea]er
or SHARP AUTHORIZED SERVICE STATION
Choosing a Location for Your Oven
Ov_ c=vt_i
You will use your oven frequently so plan its location for ease of use, The oven must be placed on a countertopwhich is a minimum of
36 inches from the floor, Allow at least 2 inches on the sides, top and at the rear of the oven for air circulation,r Be sure to position oven
so that the rear cannot be touched inadvertently
Do not place or install the oven in any area where heat and steam are generated; for example, next to or above a conventional gas or
electric range or above a conventional wa!l oven° Heat and steam may damage the electronics orthe mechanical parts of the oven.
Built-in Kit
Your oven can be built into a cabinet or wall--not near or above a heat source--using Sharp's Built-in Kit, Model RK-71 and RK-71W..
Model RK-71 is for R-7A85 oven, and Model RK-7 lW is for R-7A95 oven If your dealer does not stock the kit, it can be ordered directly
from the Sharp Accessories and Supp{ies Center, Have your credit card number available and call toll-free:
1-800-BE-SHARP for ordedng the kit to be sent to your address
The kit incfudes ducts and finish trim stnps and easy-to-follow instructions for installation as well as the location of the power supply
It is important that ail instructions for electrical connection and grounding be followed to eliminate any hazard or chance of
electrical Short circuit, Grounding reduces the risk of electric shock by providing an escape wire for the electric current°
All electrical work must be in accordance with the National Electrical Code and all
local codes and ordinances.,
WARNING
- improper use of the grounding ping can resuit in a risk of electric 3-P,eng Plug
shock_
Electrical Requirements
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp or more fused
electrical supply,, tt is recommended that a separate circuit serving only the oven be
provided
The oven is equipped with a 3-prong grounding plug, it must be plugged into a walt
receptacle that is properly installed and grounded° Should you onfy have a 2-prong
outlet, have a qualified electrician install a correct wall receptacle
A 3-prong adapter may be purchased and used temporarily if toca_ codes allow
Follow package directions
A short power-supply cord )s provided to reduce risk of becoming entangled in or
tripping over a longer cord,
Extension Cord
If it is necessary to use an extension cord, use only a 3-wire extension cord that has
a 3-blade grounding plug and a 3-stot receptacle that will accept the plug on the
microwave oven The marked rating of the extension cord should be AC 115-120 volt,
15 amp or more,
Be careful not to drape the cord over the countertop or table where it can be pulled
on by children or tripped over accidentally.,
Note:
1,. If you have any questions about the grounding or electrical instructions, consuft
a qualified etectdcian or serviceman
2 Neither Sharp nor the dealer, can accept any liability for damage to the oven or
personal injury resulting from failure to observe the correct electrical connection
procedures.
Radio or TV interference
Should there be any interference caused by the microwave oven to your radio or TV,
check that the microwave oven is on a different electrical circuit, relocate the radio
or TV as far away from the oven as feasible or check position and signal of receiving
antenna,,
' i,oilRocop
/
Grounded
Receptacle Box
Permanent and Correct installation
Grounded
Greunding Receplacle Box
Adaptor
Tab for
Grounding Screw
Temporary Use