Troubleshooting for Anynet +
Problem
Anynet + does not work.
I want to start Anynet +.
I want to exit Anynet +.
The message 'Connecting to
Anynet+ device...' appears on
the screen.
The Anynet÷ device does not
play.
The connected device is not
displayed.
The TV program cannot be
recorded.
The TV sound is not output
through the receiver.
•
Check if the device is an Anynet + device. The Anynet+ system supports Anynet + devices only.
•
Connect only one receiver (home theater).
•
Check if the Anynet + device power cord is properly connected.
•
Check the Anynet+ device's Video/Audio/HDMI 1.3 cable connections.
•
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
•
Check whether the TV remote control is in TV mode.
•
Check whether it isAnynet + exclusive remote control.
•
Anynet+ doesn't work in certain situations. (Searching channels, Operating Media Play,
Plug & Play, etc.)
•
When connecting or removing the HDMI 1.3 cable, please make sure to search devices again or
turn your TV off and on again.
•
Check if the Anynet + Function of Anynet + device is set on.
•
Check if the Anynet+ device is properly connected to the TV and check if the
Anynet + (HDMI-CEC) is set to On in the Anynet + Setup menu.
•
Press the TV button on the TV remote control to switch to TV. Then press the TOOLS button to
show the Anynet + menu and select a menu you want.
•
Select View TV in the Anynet + menu.
•
Press the SOURCE button on the TV remote control and select a device other than Anynet+
devices.
•
Press v
CN A, CH LIST, PRE-CH, and FAV, C H to change the TV mode. (Note that the
+
not connected, l
channel button
when a tuner-embedded Anvnet device is
•
You cannot use the remote control when you are configuring Anynet + or switching to a view
mode.
•
Use the remote control when the
+
A
lete.
•
You cannot use the play function when Plug & Play is in progress.
•
Check whether or not the device supports Anynet + functions.
•
Check whether or not the HDMI 1.3 cable is properly connected.
•
Check whether Anynet + (HDM!-CEC) is set to On in the Anynet + setup menu.
•
SearchAnynet + devices again.
•
You can connect an Anynet + device using the HDMI 1.3 cable only. Some HDMI cables may not
support Anynet + functions.
•
If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power cord
or a power failure, please repeat the device scan.
•
Check whether the antenna jack on the recording device is properly connected.
ei: . ...............................................................................
[8500-NA]BNdS-02322C-Eng.indb
65
2009-07-28
_ _ 11:23:48