Exercise Cycle Operation; How To Install The Receiver For The Optional Chest Pulse Sensor; How To Adjust The Position Of The Seat; How To Adjust The Pedal Straps - Reebok RB 345 User Manual

HOW TO INSTALL THE RECEmVER FOR THE OPTmONAL CHEST PULSE SENSOR
if you purchase the optional chest pulse sensor (see page 19), follow the steps bebw to install the receiver
included with the chest pube sensor,
1, See assemMy step 4 on page 5, and remove the two
M4 x 25mm Screws (not shown) and the Bookrack
(55),
Next, bok under the consob and bcate the three indi-
cated screws (not shown), Remove the three screws,
Do not remove the screws attaching the Console to
the Handlebar Post (6}.
2, Carefully lift the top of the Console (9) as shown, Using
the two small screws included with the chest pulse sen-
sor, attach the receiver to the indicated plastic posts on
the Console, Make sure that the receiver is turned
e×actly as shown. Connect the wire on the receiver to
the indicated wire on the Consob,
See step 1 above, Lower the top of the Consob (9),
Make sure that no wires are pinched. Reattach the
top of the Consob with the three screws removed in
step 1, See assemMy step 4 on page 5, and reattach
the Bookrack (55) with the two M4 x 25mm Screws (not
shown), Note: The remaining wires included with the
chest pulse sensor may be discarded,
55
HOW TO ADJUST THE POSITION OF THE SEAT
For effective exercise, the seat should be in the proper
position, As you pedal, there should be a slight bend
in your knees when the pedals are in the farthest
position, To adjust
the seat, pull the
seat knob and
slide the seat car-
riage to the desired
position, Release
the seat knob and
stide the seat car-
riage back and
forth slightly until
it tocks into posi-
tion.
Seat
Seat
Knob
HOW TO ADJUST THE PEDAL STRAPS
To adjust the pedal
straps, first pull the
ends of the straps
off the tabs on the
pedals, Adjust the
straps to the
desired positions
and press the ends
of the straps back
onto the tabs,
Strap
8