Table of Contents
Advertisement
D
TROUBLESHOOTI
NG TIPS
No power
•
Check to make sure it is plugged
into an operating
outlet.
•
Check to make sure your connections
are correct.
VCR does not respond
to remote
•
Press VCR to set remote to control
the VCR.
•
Check to make sure there are no objects between
the VCR and remote.
•
The batteries
may need changing.
•
Make sure the Remote VCRI/VCR2 setting
is set to VCR1 so the remote that came packed with your VCR can operate
it.
Remote
no longer controls
an RCA, ProScan, or GE TV
•
Press TV to set remote to control
a compatible
TV.
•
Check to make sure the remote
is programmed
to control an RCA, ProScan, or GE TV.
Remote
no longer controls
a compatible
TV
•
Press TV to set remote to control
the corresponding
component.
•
Check to make sure there are no objects between
the component
and remote.
•
The batteries
may need changing.
•
Reprogram
remote after batteries have been changed.
•
Remove batteries
and hold number
button
1 for at least 60 seconds to drain the microprocessor
inside the remote.
Release number 1, replace the batteries,
and (if necessary) reprogram
the remote.
Poor or no picture for normal
TV viewing
•
Check to make sure the VCR indicator
is off.
•
Check to make sure the TV is switched
to an active channel.
•
Check to make sure the antenna
connections
are secure and correct.
Snowy
or no picture during
playback
•
Press TV•VCR to turn VCR indicator
on.
•
Check TV channel selected (3 or 4) to make sure it matches the channel selected with 3 CH. 4 switch on
back of VCR.
•
Check to make sure the TV's fine tuning
is correct for the channel you have selected.
•
Check video cable connections
between
VCR and TV monitor.
•
Check to make sure the TV monitor
is set to video input.
•
Try another
tape.
•
Some snow/streaks
are normal during
search, stop action, frame advance, and slow-motion
playback.
continued
on next page
59
Advertisement
Table of Contents
