Table of Contents
Advertisement
Osing the W°s Features
6. Pressthe down arrow button to highlight Alarm type. Pressthe right arrow button to highlight
the type of alarm you want to hear when receiving an Advisory. If you don't want any alarm set,
choose None.
Notes: Formodels20F670T, 2 7V570T and 27F670T, d on"tleaveheadphonesplugged in when they aren't in use
Alarms will sound through the headphonesand not the 7Vsspeakers,causing alarms not to be heard.
If your TVis connected to a receiver,ampfi_r, home theater system, or otheraudio equipment, alerts won't be
audible through such devicesconnected to the audio output terminalsof the _ instead, theAlert¸Guard
system will turn on the 7Vs internal speakersto sound an alarm and make the alerts audible¸
7. If you set an Alarm type, press the down arrow button
to highIight
AIorm volume. Press the
right or left arrow button to set the highest volume of the alarm. You might want to think of
how loud the volume needs to be if you're somewhere else in your home. For example, if you
want the alarm to wake you up while sleeping in the other room, then you might need to set
the volume at the highest level.
The Siren option
is a loud sound, designed to get your attention.
The Chime option is a subtle
sound for those easily startled. When the Siren or Chime sounds, it starts soft and continues to
get louder until it reaches the maximum volume you set. The Voice option is the voice of NWR
which states the alert and then shuts off. The Voice option doesn't get louder. It speaks at the
volume you set.
8. When finished, if you want to customize
Warning or Watch level, press the up or down arrow
button
to highlight
Alert level. Then follow steps 4-7.
Locations
You can receive alerts from three other locations within close
proximity
of where you live. To set these areas:
1. Press the MENU button
(the MAIN MENUappears).
2.
Press the down arrow button
to highlight
Alert Guard
and press OK.
3.
Seleet Locationsfrom
the ALERT GUARD menu.
4.
Press the left or right arrow button
to choose which area
you want to set, for example Nearby 1 (if you completed
the Alert Guard initial setup, MyArea
has already been
set). Set the areas in order of priority.
5.
Press the down arrow button
to highlight
Noarea.
6.
Press the right arrow button to highlight
the state,
territory, or marine area where you are living or District
of Columbia. These are listed in alphabetical
order, with
marine areas at the end of the list (press the left arrow
button
to access these quickly).
7.
Press the down arrow button
to highlight
AII nearb)_
8.
Press the right arrow button to choose another area
different
than the area set for MyArea. This could be
another county, city, parish, area, borough, district, island,
atoll, state or municipality
nearby where you are living.
The location code is now set. If you want to set another
area, press the up arrow button
to highlight
Location.
Press CLEAR to exit.
20
Graphics contained
within this publication
are for representation
only
Chapter 3
Advertisement
Table of Contents
