RCA PR42300 User Manual page 44

REFERENCE
CONNECTINGYOUR
PC OR
MACINTOSH
COMPUTER
MINI D-SUB
15 PINVGA
SIGNAL
COMPOSITION
Connecting your PC or Macintosh computer to your
Cinema Screen monitor will enable you to display
computer images on the monitor. The Cinema Screen
monitor supports the signals described on page 48.
To connect to a PC, Macintosh or compatible graphics
adapter:
1.
2.
Turn off the power to your monitor and computer.
If your PC does not support XGA/SVGA/VGA you will
need to install an XGA/SVGA/VGA graphics board.
Consult your computer's owner's manual for your
SXGA/XGA/SVGA/VGA configuration. If you need to
install a new board, see the manual that comes with
your new graphics board for installation instructions.
.
The Cinema Screen monitor provides signal
compatibility with VESA 128021024@60MHz (SXGA).
However, we recommend not using this resolution due
to image readability on the monitor's 853 X 480 native
pixel resolution panel.
4.
Use the signal cable that's supplied to connect your PC
or Macintosh computer to the Cinema Screen monitor.
For Macintosh, you will need a monitor adapter (not
supplied) to connect to your computer's video port.
5. Turn on the monitor and the computer.
.
If the Cinema Screen monitor goes blank after a period
of inactivity, it may be caused by a screen saver
installed on the computer you've connected to the
monitor.
When using a Macintosh with the Cinema Screen
monitor, the following three display standards are
supported using the included Macintosh adapter : 13"
fixed mode, 16" fixed mode, and 19" fixed mode. The
13" fixed mode is recommended for the Cinema Screen
monitor
Pin No. Signal to be connected
1 RED
2 GREEN or sync. on Green
3 BLUE
4 No connection
5 GND
6 RED (GND)
7 GREEN (GND)
8 BLUE (GND)
9 No connection
10 SYNC (GND)
11 No connection
12 SDA
13 H. Sync
14 V. sync
15 SCL
43