Table of Contents
Advertisement
ABOUT
PROGRAMMING
THE REMOTE
The universal remote
can be programmed
to control most
brands of remote controllable TVs, VCRs, and cable boxes. Most
RCA, GE and ProScan TVs and VCRs are already programmed.
Other manufacturers'
brands need to be programmed.
PROGRAMMING
TH E REMOTE
TO
CONTROL
A VCR
To determine
whether
the universal remote
needs to be
programmed,
turn
the VCR on, point
the remote
at the VCR,
and press the VCR1 button.
Then press POWER or CHAN UP or
DOWN to see if the VCR responds to the remote
commands.
If
not, the remote
needs to be programmed.
Follow these steps to program
your universal
remote to
control
your VCR:
1.
Turn on the VCR to be programmed.
2.
Look up your VCR brand and code number(s)
on the code
list on the next page.
3.
Press and hold the VCR1 button
on the remote.
4.
Enter the two-digit
code from the code list.
5.
Release VCR1 then
press POWER to see if the VCR
responds tothe
remote
commands.
If it doesn't,
try
pressing VCR1 and POWER to see if the VCR responds.
This remote
may not operate
all
models
of the brands
that
are
shown.
Use the codes on the next
page or on the sheet
packed
with
your
remote.
24
To program
the VCR2oLDbutton
to control
a second
VCR, follow
these
steps but use the VCR2,LD
button
instead of the VCR1 button.
Advertisement
Table of Contents
