Table of Contents
Advertisement
ABOUT
PROGRAMMING
THE
REMOTE
The universal remote
can be programmed
to control most
brands of remote controllable
TVs, VCRs, and cable boxes.
Most RCA, GE and ProScan TVs and VCRs are already
programmed.
Other manufacturer's
brands need to be
programmed.
PROGRAiV_N_ING
THE
REMOTE
TO CONTROL
A VCR
To determine
whether
the universal remote needs to be
programmed,
turn the VCR on, point the remote at the VCR,
and press the VCR1 button. Then press POWER or CHAN UP or
DOWN to see if the VCR responds to the remote commands. If
not, the remote needs to be programmed.
Follow these steps to program your universal remote to
control your VCR:
1.
Turn on the VCR to be programmed.
2.
Look up your VCR brand and code number(s) on the code
list on the next page.
,
4.
5.
Press and hold the VCR1 button
onthe
remote.
Enter the two-digit
code from the code list.
Release VCR1 then
press POWER to see if the VCR
responds to the remote
commands.
If it doesn't,
try
pressing VCR1 and POWER to see if the VCR responds.
,
.
-..
ii
I
i
o,
II
I
Ir
This remote
may not operate
all
models
of the brands
that
are
shown.
Use the codes shown
at
right
or on the sheet
packed
in
with
your
remote.
To program
the VCR2.LD
button
to control
a second
VCR, follow
these
steps but use the VCR2-LD
button
instead
of the VCR1
button.
ii
tl
"
I
I
m=
4
" ._
Advertisement
Table of Contents
