Table of Contents
Advertisement
C@nnec @n
Ne up
Step 3: Configuring
for a VCR
1.
It your TV is connected
to a VCR, press OK (a screen appears
reminding
you to connect your G-LINK cable to your TV and VCRX
It it is not, highlight A"0and press OK.
2,
Use tile tip and down arrow buttons to highlight the brand of your VCP, that
is connected
to the TV and press OK,
If your brand isn't listed, highlight
NOt Listed and press OK,
.
Tune
your VCR lo channel
02.
Next,
turn OFF your VCR. When
you
complew
these
steps,
press
OK to begin
resting.
Important
Note: When code testing is in progress, don't touch your TV, VCR, or
any of the remote controls for these products.
4.
Look at tile front of your VCR, If y()ur VCR mined
on automatically
and
changed
to channel 09, tile test was StlCCessltll. Highlight
Yes and
press OK,
Ii your VCP, didn't change to channel 09, you can either choose NO or 7_st
this code _(gain.
If you think your T'_ or remotes
might have been touched
during the test,
rune your VCR to channel 02, mrn oil your \ CP, and highlight
Test this
cod_, agai_z,
It you don't think the test was interrupted,
highlight A'0. Tune your VCR to
channel 02 and turn off your VCR. Press OK (tile G{IDE Plus+ system starts
testing another set ot codes.)
Keep inllnwing the previous instructions
until tile VCR finds tile
correct cnde,
Chapter
I
19
Advertisement
Table of Contents
