Table of Contents
Advertisement
C@nnect @ns
Setup
Why You Should Connect This G-LINK Cable
The G-LINK cable enables the GUIDE Plus+ system (tile on-screen
interactive prograln guide) to
work with your VCR and/or cable box.
Cable Box-
If your TV is connected
to a cable box you must connect tile G-LINK cable to
receive TV program
listings lk_r your area, and to tune directly to a channel when the prograln
guide is on your TV screen.
VCR-- If your TV is connected
to a VCR and you don't connect
the G-LINK cable, one-touch
VCR recording
won't work. The other fl.atures of the guide will work properly.
2.
G-LINK wands
How to Find the Remote
Sensor
You have to place the (}-LINK wands in t)ront of lhe remote sensor on lhe VCR and/or cable box.
Some cable boxes and VCRs have tile remote sensor labeled on the unit. If tile remote sensor isn't
labeled on your VCR and/or cable box, you need to use the remol_, control that came with the VCR
and/or cable box to locate the sensor.
.
1.
Turn off the VCR and/or cable box.
Hold the remote control (not tile one that came with your TV, but tile one that calne with the
cable box and/or VCR to which you're attaching tile G-LINK cable) so that it is touching
the
l}ont ot tile conlponent.
Slowly move the remote control across the front of tile component
(VCR or cable box) while
you press the power button on and oil'. You nlust press and release the power button each time
you move the remote (holding
down the button won't work).
4.
When
the component
turns
on, you've
located
the remote
sensor.
Placing the G-LINK Wands
Place the G-LINK wands in l_cont of the remote sensor on your VCR and/or cable box approximately
one inch away [_comthe remote sensor (see instructions
below).
TV(back pan_l)
np
If you don't have both a
cable box and a VCR
connected to your TV,just
coil the cable of the extra
G-LINK wand with a twist
tie and leave it behind the
T_
14
Chapter
I
Advertisement
Table of Contents
