Table of Contents
Advertisement
Using Two VCRs for Copying
and Editing
Tapes
Operating
Instructions
(Refer
to hookup
on page 6.)
Use one VCR as the playback
VCR and the other as the recording
VCR. If you have two compatible
VCRs, use the
AutoEdit
TM
feature described below.
,Caution:
The unauthorized
recording
of televLsion
?rograrns
and
other
:materials
may
infringe
the
:rights of others.
1.
Turn on the TV and VCRs.
2.
3.
4.
5.
6.
7.
8,
Tune TV to the VCR viewing
channel, either 3, 4, or TV's
video input.
If you have connected
your VCR using Option
A (page 6), tune
recording
VCR to channel
3 or 4 - the one selected on the back
of the playback
VCR.
If you have connected
your VCR using Option B (page 6),
press INPUT on recording
VCWs remote to select the line
input.
Insert the tape you want to copy into playback
VCR. Insert a
blank tape with safety tab in place into recording
VCR.
Press PLAY, then PAUSE on playback
VCR when you reach
the point on the tape or program
where you want to begin
copying.
If the tape was not recorded
on the playback
VCR,
streaks may appear
and you may need to adjust TRACKING.
Press REC-XPR,
then PAUSE, on recording
VCR.
Press PAUSE buttons
on both VCRs at the same time to begin
copying
the tape.*
Edit out segments
that you do not want to copy by pressing
PAUSE on recording
VCR to stop copying the tape. Then,
locate the next segment you want to copy on playback
VCR by
using F.FWD, REWIND, and PLAY. Press PAUSE on the
playback
VCR. Press PAUSE at the same time on both VCRs
to resume
copying.
9.
Press STOP on both VCRs when you are finished.
* You may turn off the TV after the recording
has started
as it does
not have to be on to copy a tape.
Using
Dual
Remote
with
AutoEdit
TM
Use this VCR as the recording
VCR and set it to respond
to VCR2.LD on the remote as
described on page 11. Use your other compatible
VCR as the playback
VCR, which should
respond
to VCR1.
1.
Follow steps 1- 4 in the "Operating
Instructions"
above.
2.
Press VCR2oLD on remote to control recording
VCR. Press
RECoXPR, then PAUSE, to put recording
VCR in pause mode.
3.
Press VCR1 on remote to control playback
VCR.
4.
Use F.FWD, REW. and PLAY to locate the point where you
want to begin copying.
Press PAUSE while VCR is playing
to
put playback
VCR in pause mode.
5.
Press EDIT on remote;
the VCRs will begin copying.
6.
Press EDIT again when you want to stop the tape from
copying.
7.
Repeat steps 4- 6 as needed.
8.
Press VGR1, STOP, then VCR2°LD, STOP, when you are
finished.
31
Advertisement
Table of Contents
