Using Two Vcrs For Copying And Editing Tapes - RCA VRS420 User Manual

USING TWO VCRS FOR COPYING AND EDITING
TAPES
Use one VCR as the playback VCR and the other as the
recording VCR.
1. Turn on the TV and VCRs.
.
.
.
.
.
.
Tune the TV to the VCR viewing channel (either 3, 4, or TV's
video input).
If you connected your VCR using the ANT.IN and RF OUT
jacks, tune the recording VCR to channel 3 or 4--the one
selected on the back of the playback VCR.
If you connected your VCR using the audio/video jacks, press
INPUT on the recording VCR's remote to select the line input.
Insert the tape you want to copy into the playback VCR.
Insert a blank tape with safety tab in place into the
recording VCR.
When you reach the point on the tape or program where you
want to begin copying, press PLAY-PAUSE and then
PLAY.PAUSE again on the playback VCR. You may need to
adjust the tracking.
Press the RECORD button, then press PLAY.PAUSE, on the
recording VCR.
Press the PLAY-PAUSE buttons on both VCRs at the same
time to begin copying the tape.
8. To edit segments that you do not want to copy:
• Press PLAY-PAUSE on recording VCR to pause copying.
• Locate the next segment you want to copy on playback
VCR by using FWD, REV, and PLAY.PAUSE, and then press
PLAyoPAUSE.
.
• Press PLAY-PAUSE on both VCRs at the same time to
resume copying.
Press STOP.EJECT on both VCRs when you are finished.
Caution:
The unauthorized recording of
television programs or other
copyrighted materials may infringe
on the rights of others.
Two VCR Connection
. CABLE BOX
O TENNA
PLAYBACK VCR
I
A NTIN I I
(f --/
TO TV TO "IV
29