Table of Contents
Advertisement
Playback
Operation
1. Set the channel
selector
switch on the
RF output
adapter
to CH3 or CH4.
2. Turn on the TV and tune it to the same
channel
(3 or 4) you selected
with the
channel
selector
switch
on the RF
output adapter.
3. Press and hold the small button on the
camcorder's
CAMERA/OFF/VCR
switch
while sliding
it to VCR.
4. Insert the cassette
you want to play
back into the camcorder.
Note: The camcorder can only play back
tapes recorded at the SP speed.
5. Press PLAY on the camcorder.
Adjust
tracking
on the camcorder,
if
necessary.
Details
are on page 49.
• During
playback,
use the playback
features
described
on page
49.
6. Press STOP/EJECT
on the camcorder
when you are finished
playing
back the
tape.
Watch What the Camcorder
is Seeing or Recording
on the TV :::
:::: :: ::_.! :: :
1. Turn on the TV and tune it to channel
3 or 4 (the same channel
you selected
with the CH3/CH4
switch
on the RF
output
adapter).
2. Press and hold the small button on the
camcorder'
s CAMERA/OFF/VCR
switch
while sliding
it to CAMERA.
Insert the cassette
you want to
record on.
.
Press the camcorder's
REC/PAUSE
button to begin recording.
You can
watch what the camcorder
is seeing
or recording
on the TV screen.
Note: When the camcorder is used as a
camera, turn the TV's volume down to
prevent a high-pitched
squeal caused by
feedback.
Normal TV Viewing
...... .........
For normal
TV viewing,
you can leave
the RF output adapter
hooked
up to the
TV.
Just disconnect
the adapter's
plug
from the camcorder
or turn the
camcorder's
power off.
Note to Cable-TV
Installer:
This reminder
is provided
to call your attention
to Article
820-40
of the National
Electrical
Code (Section
54 of Canadian
Electrical
Code,
Part I), that provides
guidelines
for proper grounding
and, in particular,
specifies
that the
cane
ground
shall be connected
to the grounding
system
of the building
as close to the
point of cable entry as practical.
53
Hide quick links:
Advertisement
Table of Contents
