RCA CC439 User Manual page 43

Audio and Video Dubbing
The audio and video dubbing feature lets you record new
audio (sound) and video (picture) on a previously recorded
tape in the camcorder.
The source for the dubbing is:
• the camcorder's built-in microphone and camera
(applicable to CC434 and CC439) or
• a source connected to the AUDIO/VIDEO jacks on the
side of the CC439 camcorder only.
To Audio and Video Dub
1. Press and hold the small button on
CAMERA/OFF/VCR while sliding it
to VCR.
2. For CC439 model, if you are
recording from a source connected to
the AUDIO/VIDEO jacks on the side
of the camcorder, place the A V
OUT/IN switch to IN.
3. Insert the tape you want to dub and
use PLAY, F.FWD, and REW/
REVIEW to locate a point on the tape
a few seconds before you want to
begin dubbing.
4. Press REC/PAUSE exactly where you
want to begin dubbing. This will place
the camcorder in play pause.
5. Press and hold AVDUB, and then
press PLAY. Release both buttons at
the same time. A. DUB II will appear
in the viewfinder when the camcorder
is ready to begin audio dubbing.
6. Press and hold AVDUB, and then
press PLAY again. Release both
buttons at the same time. A/VDUB
II
will appear in the viewfinder when the
camcorder is ready to begin audio and
video dubbing.
A/V DUB
II
Note: For CC439 model only, if you are
dubbing from a source connected to the
AV OUT/IN jacks, be sure to start it
playing.
7. To begin dubbing, press REC/PAUSE.
II
will disappear from the viewfinder
while you are dubbing.
8. Press STOP/EJECT when you are
finished dubbing.
Remember: For CC439 only, place the
AV OUT/IN switch to OUT to record on
the camcorder.
Notes: If you want to stop dubbing at a
certain point on the tape, turn on memory stop
and set the tape counter to "O000M" at the
point where you want the dubbing to stop.
The camcorder will stop dubbing
automatically when it reaches "O000M."
41
J:
i_ •
!,
_.
:_,
_Y