ProForm CROSSWALK 380 User Manual page 45

13. Attach the Latch Housing (48) to the Left
Upright (53) with two #10 x 1" Tek Screws
(112); start both Tek Screws before tighten-
ing either of them. Make sure that the large
hole in the Latch Housing is on the indicated
side.
Locate the Latch Pin Assembly (24), Remove
the knob from the pin, Make sure that the collar
and the spring are on the pin. (Note: if there are
two collars, place one on each side of the
spring.) insert the pin into the Latch Housing
(48). Then, tighten the knob onto the pin.
13
24
Kn(
112
Large Hole
Collar
Pin
14. Attach the Left Crosswalk Arm (73) to the Left
Upright (53) with two 1/4" Flat Washers (32) and
two 1/4" x 3" Bolts (111 ), Make sure that the Left
Crosswalk Arm is on the indicated side of the
Console Assembly(91).
Attach the Right Crosswalk Arm (not shown)
in the same way. Be careful not to pinch the
wires in the Right Upright (not shown).
14
111
32
15. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys
in a secure place. One hex key is used to adjust the walking belt (see page 23). To protect the floor or carpet,
place a mat under the treadmill.
13