ProForm Cardio Crosstrainer 820 User Manual page 7

5, 5
The ConsoUe (5) requires four "D" batteries (not incUud-
ed); aHkaHnebatteries are recommended, Remove the
indicated screw from the battery drawer, and puHH the
battery drawer open, Hnsert four batteries into the bat-
tery drawer; make sure that the batteries are orient-
ed as shown by the markings inside the battery
drawer. CHosethe battery drawer and reattach the
screw, Note: When the batteries are instaHHed correctly,
the fan wHH turn on for a moment,
Hdentifythe Left HandHebar (9), which is marked with a
sticker, Hnsertthe Left HandHebar into one of the
HandHebar Legs (79); make sure that the Handlebar
Leg is turned so the hexagonaJ holes are on the
indicated side, Attach the Left HandHebar to the
HandHebar Leg with two M8 x 45mm Button BoHts(50)
and two M8 NyHon Locknuts (46), Make sure that the
NyJon Locknuts are inside of the he×agonat holes.
Do not futty tighten the Button Bolts yet.
Apply a generous amount of the included grease to the
Pivot Axle (97) and to the two M8,5 Washers (53), insert
the Pivot Axle into the Upright (2) and centre it, Reappiy
grease to both ends of the Pivot Axle,
Slide a Handlebar Spacer (25) onto the short tube on the
Left Handlebar (9), and rotate the Handlebar Spacer so
the arrow is pointing toward the floor, Then, slide the Left
Handlebar onto the Pivot Axle (97), Make sure that the
Left Handlebar is on the correct side. Turn an M8 x
25mm Patch Screw (22) with an M8,5 Washer (53) and
a Wave Washer (95) into the end of the Pivot AxHe,
Attach the Right HandHebar and the other HandHebar Leg
(not shown) to each other and the Pivot AxHe (97) in the
same way, Next, tighten the two M8 x 25mm Patch
Screws (22) into the Pivot AxHe,Press the smaHH tabs on
the HandHebar Caps (23) into the two HandHebar Spacers
(25),
HoHdthe Hower end of the HeftHandHebar Leg (79) inside
of the HeftFront FHexBracket (17), AppHy a smaHH
amount of grease to an MIO x 78mm Button BoHt(27),
Attach the HeftHandHebar Leg to the HeftFront FHex
Bracket with the Button BoHt,two MIO Washers (38),
and an MIO NyHon Locknut (29), Do not overtighten
the NyJon Locknut; the teft Handlebar Leg must be
able to pivot freely.
Attach the right HandHebar Leg (79) to the right Front
FHexBracket (17) in the same way,
See step 6, Tighten the M8 x 45mm Button BoHts(50)
in the HandHebar Legs (79), See step 3, Tighten the
MIO x 88mm Button Screw (63),
7
27
5
Batteries
/
/
Screw
Battery
Drawer
Grease
Tube
t
53 / !7 _'i
22 25
krrow
I
-p_79
I
!
38
17
Grease
17