ProForm 515 s CrossWalk User Manual page 9

8. Press the Upright Wire (42) into the slot in the underside
of the Console Base (47) in the indicated area. Cover the
Upright Wire with the Right Grip Plate (36). Be careful
not to pinch the Upright Wire. Tighten three 3/4"
Screws (2) into the Right Grip Plate and the Console
Base.
Attach the Left Grip Plate (32) over the ground wire and
the other wires with three 3/4" Screws (2). Be careful
not to pinch any of the Wires.
47
9. With the help of a second person, lower the Uprights
(69) to the floor.
Align the lower ends of the Handrails (71, 72) with the in-
dicated holes in the Extension Legs (63). Attach each
Handrail with a 3" Bolt (37) as shown. Note: The Bolts
must be at an angle that matches the angle of the
Nandrails, as shown in the inset drawing. Firmly
tighten the Bolts.
With the help of a second person, carefully tip the
Uprights (69) back to the vertical position.
63
37
37
%
63
10.Attach the Storage Latch (29), with the Latch Spacer
(121), to the left Upright (69) with two 3/4" Screws (2) as
shown. Do not overtighten the Screws.
10
69
11.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 24). To protect the floor or carpet, place a mat under the treadmill.
9