Programming The Universal Remote; To Control A Vcr - ProScan PS60690 User Manual

PROGRAMMING THE
UNIVERSAL REMOTE
You can program the universal remote to control most brands of
remote controllable TVs, VCRs, and cable boxes. If you have an RCA,
GE or PROSCAN VCR, you may not need to program the remote at all.
Other manufacturer's brands need to be programmed.
Programming the Universal Remote to Control a VCR
To determine whether you need to program the universal remote, turn
on the VCR, point the remote at the VCR and press the VCR1 button.
Then, press POWER or CHAN A or CHAN v to see if the VCR responds
to the remote commands. If not, you need to program the remote.
Follow these steps to program your universal remote to control your
VCR:
1. Turn on the VCR to be programmed.
2. Look up your VCR brand and code number(s) in the code list on the
next page or on the code sheet packed with your remote.
3. Press and hold the VCR1 button on the remote.
4. Enter the two-digit code from the code list.
5. Release VCR1, then press POWER to see if the VCR responds to the
remote commands. If it doesn't, try pressing VCR1 and POWER to
see if the VCR responds.
6. Repeat steps 3 through 5 using the next code listed for your brand
until the VCR responds to the remote commands.
VCR2 • LD
©©
AMeFM TAPE AUX
0 0 ©
REW PLAY FF
REC STOP PAUSE
l-i-! r-.-1
GUIDE CHAN SKIP
MUTE CHA'_ PREV CH
:0
INPUT ANTENNA
O ° 0 O
DISPLAY CLEAR RESET SCAN
MENU FETCH
PROGRAM V
PiP POP SPLIT CH CTRL
_ _ _SIZE SWAP FREEZE _'(_:7
PROSCAN
This remote may not operate all
models of the brands shown-on the
next page.
To program theVCR2oLD button to
control a second VCR, follow the steps
on this page, but use theVCR2oLD
button instead of the VCR I button.
For instructions on programming the
simple remote, see page 28.
22