Table of Contents
Advertisement
Connections
& Setup
." 03
3.
Highlight
the channel
to which
you have to tune your TV in order
to see
cable
programming,
and
press
OK (a screen
appears
reminding
you to
connect
your G-LINK cable
to your TV and cable
box).
Notes:
Channel
03 is the most commo_L
Choose Video I/A UX if your cable box is con netted to ),our TV with a udio/video
cables inst;_ad of a coaxial cable. Go to page 7 for pictures of these cables.
4.
Highlight
your brand of cable
box, and
press
OK.
_,_,w,,**-_-,p
_m**,***,_,_,
If your brand isn't listed,
highlight
Not Listed and
press
OK.
5,
Make sure your cable box is on.
Tune the cable box to channel
02 (use the remote control
that came with
your cable box, or press the channel
buttons
on the cable box).
Press OK (the GUIDE Plus+ system starts testing codes).
Important Note: When code testing is in progress, don't touch your TV, VCR,
cable box or any of the remote controls for these products.
6.
Look
at your cable box, If it is still on and changed
to channel
09, the test
was successful.
Highlight
Yes, and press
OK (STEP 3: Configuring
for a VCR
appears).
If ),our cable
box didn't
change
to channel
09 or turned
itself off, you have
two choices:
No and
Test this code again.
Test this code again: lfyou
think
the TV, the cable
box, or any of the remote
controls
might
have been
touched
or bumped
during
the test, highlight
7bst
this code again and
press OK (the GUIDE
Plus+ system
runs
the same
set of
codes).
No: If you don't
thinkthe
test was interrupted,
highlight
No and
press OK
(GUIDE
Plus+ system
tests the next code).
Repeat
the previous
instructions
until
the TV finds
the correct
cable box
code.
Follow
the instructions
on the screen.
Note: If the TV can't find your cable box code, a troubleshooting
checklist
appea_s. Carefully revieTu each checklist and foUow the instructions
on the screen.
Chapter
1
17
Advertisement
Table of Contents
