ProScan PSVR85 User Manual page 77

HOW
TO FIND YOUR
TV's
VIDEO INPUT CHANNEL
You need to tune your TV to the Video Input Channel if you are
using the VCR's AUDIO/VIDEO OUT jacks to connect to the
TV's AUDIO/VIDEO INPUT jacks. You must select this
"channel" before you can see the VCR's menus, the cable or
antenna reception, and the content that's on a tape.
The Video Channel on TVs varies for different brands and
different models. Below are some steps to try:
• If your TV brand is RCA, GE, or PROSCAN, press the TV
button on the remote control that came with the VCR. Then
press the INPUT button on the remote.
• If you have another brand of TV, consult the section,
Programming The Remote, to see if the VCR's remote
contro{ can be set to control your TV. If so, follow the step
above.
If those options do not work, try the following ideas. You might
access the Video Input Channel by:
• pressing a button on the remote (see table below)
• selecting the channel from the TV's menu system
(see table below)
• tuning directly to the channel by selecting a specific
channel number (see table below)
• going through all the channels in the channel list by
pressing the channel up or down buttons on the TV.
Some common scenarios are listed in the Video Input Channel
Variations table that follows:
Video Input Channel Variations
Button/Switch Button on the Channel
on the TV TV Remote Number
VIDEO VID 1 00
SIGNAL LINE 90
VID I VID 91
VID 2 VIDEO 92
S-VID S-VID 93
S-VIDEO INPUT VID I
S-VIDEO VID 2
SOURCE
AU×
INPUT
Button
TV Button
VCA1 ON'OFF
DVD VCR2 AUX SAT.CABLE
MUTE SEAROH
®
@
SPEED _ GO BACK
GUIDE INFO
0 :20
MENU CLEAR
QC>
RECORD STOP PAUSE
-TRACKING+ EDIT FRADV
0000
75