Table of Contents
Advertisement
Using
the
Remote
Control
Continue pressing PLAY unlil llle component
turns off or llle indicator lighl
on llle remote turns oft'. If llle indicator light turns off, then all codes for that
particular component
have been tested once. If the component
does not turn
off', dmn the remote can't be progrm:qmed to operate dlat component.
If llle component
you want to control does turn off:
1.
Press and release REVERSE, then wait 2 seconds. Repeat this step until the
device turns back ON.
2.
To finish, press and hold STOP until the indicator on tile remote turns off.
A code that controls your component
has been saved to that remote button.
Important
You must continue pressing the component
button while you enter the code.
Let's say you have a Zenith
DVD playe_
To
program
the universal remote
to operate the
DVD player, you would:
Press and hold the DVD button
while you
enter the first code listed for Zenith
in the
DVD Codes column.
Release the DVD button.
Press ON*OFF to
see if the DVD player responds. If it doesn't,
follow
the same steps, but enter the second
code for Zenith
DVD players instead
of the
first.
Using Direct Entry
1.
Turn on the component
to be programmed.
2.
Look up the brand and code nm:qber(s) for the co_:qponent on the code list
in this section.
3.
Press and hold the component
button you want to program
on the remote.
4.
Enter llle code from the remote control code list on llle following pages. If
dm indicator flashes, you have either entered
an invalid code or the button
isn't programmable.
5.
Release the component
buuon, point the remote at the component
and
dmn press ON*OFF to see if tile component
responds
to tile command.
If it
doesn't,
try pressing tile component
button and dmn ON* OFF again.
*
If you get no response,
repeat these steps using llle next code listed for
your brand, until llle component
responds
to the remote commands.
*
If you fry all the codes tbr your component
brand and none work, try tile
automatic
code search method. If automatic
code search doesn't find the
code, the remote is not compatible
with your component.
Chapter
2
Graphics contained
within this publication
are fi)r representation
on/y.
21
Advertisement
Table of Contents
