Table of Contents
Advertisement
Insert lead under screws
and tighten.
300-75 Ohm Adapter
Wrap each exposed
end of wire once or twice around
the screw
shanks
of the adapter
(or insert the clips under
the screw
heads). Tighten
the screws.
O
Push the adapter
firmly onto the anten:na
terminal
on the
VCR labeled ANTENNA
IN.
O
Go to page 14, "Connecting
the Television."
O
connecting an antennawitha 75-ohmroundlead
O
Disconnect
the antenna
from the back: of the TV.
O
Connect
the anterma
to the ANTENNA
IN terminal
on the
back of the VCR. Screw or push the cable until it is tight.
O
Go to page 14, "Connecting
the Television."
Connecting separateUHF/VHFantennas
You may have two separate
antennas
(one UHF, one VHF) that
bring TV signals
into your home. If you do, you'll need to combine
the two antennas
before connecting
them to the VCR. To do this,
you'll need an attachment
called a combiner
(which is available
at
your electronics
store).
If your UHF antenna
wire looks
like this...
This chart will help you determine
the kind of combiner
you need.
... and your VHF antenqa
wire
... then you need a combiner
looks like this ...
like this.
)
To connect your antennas:
(please
see the illustration
on the next page.)
O
Disconnect
the antennas
from the back of the TV.
Connect
the antenna
leads onto the combiner.
Screw or push the combiner
onto the ANTENNA
IN terminal
on the VCR.
When you are finished,
see page 14, "Connecting
the Televi-
sion."
13
Advertisement
Table of Contents
