Advertisement
Available languages
Available languages
TROUBLESHOOTING
if you experience
First try the solutions suggested here or visit our website at www.maytag.com/help
for assistance and to possibly avoid a service call.
Possible
Causes
|
Solution
1
Once any possible issues are corrected, press POWER/CANCEL
once to clear the code. Reselect and restart the cycle.
Sud (Excess suds)
appears in display
F8E1 (water supply
error) appears in display
Excessive suds in washer. Washer is
running a suds reduction routine.
Check for proper water supply.
Allow the machine to continue. Use only HE detergent.
Always measure detergent, and base detergent quantity on
load size. Follow detergent manufacturer's
instructions.
Both hoses must be attached and have water flowing to the
inlet valve.
Both hot and cold water faucets must be on.
Inlet valve screens on washer may be clogged.
Remove any kinks in the inlet hose.
Press POWER/CANCEL
once to clear the code. Then press
POWER/CANCEL
again to restart washer. If code appears
again, call for service.
F9E1 (drain pump
Check plumbing for correct drain
Check drain hose for proper installation.
system error) appears
in display
hose installation. Drain hose extends
into standpipe farther than 41/2 ''
(114 mm).
Make sure the drain hose is not kinked, pinched, or blocked.
Remove any clogs from drain hose.
Use drain hose form and securely attach to drainpipe or tub.
Lower drain hose if the end is higher than 96" (2.4 m) above
the floor.
Use only HE detergent. Always measure detergent and follow
manufacture's
directions based on load size and soil level.
Not using HE detergent or using too
much HE detergent.
F5E2 (door will not lock) Washer door not locking.
Press POWER/CANCEL
to cancel the cycle. Make sure the
appears in display
door is closed completely
and latching. Check for items in
the washer drum that may be keeping the door from closing
completely.
F7E1 (motor drive error)
Motor is having difficulty turning
Washer is overloaded. Remove some items. See "Cycle Guide"
appears in display
the drum.
for load size recommendations.
Make sure that all shipping materials have been removed. See
the Installation Instructions.
"rL" (remove load)
Load detected in drum during Clean
Remove items from drum and restart Clean Washer
appears in display
Washer with AFFRESH
TM
cycle,
with AFFRESW M cycle.
Washer making error
Door has not been opened and closed
This code may appear when the washer is first turned on.
beeps,
for at least 3 cycles.
Open and close the door to clear the display.
Washer beeps when
Door not closed.
Close the door completely.
START/PAUSE is
pressed.
F#E# code other than
System error code.
Press POWER/CANCEL
once to clear the code. Then press
as described above
POWER/CANCEL again to restart washer. If code appears
appears in display
again, call for service.
16
Advertisement
