Maytag MVWX500XL2 Use And Care Manual page 9

CLEANING
YOUR WASHER
Keep your washer as clean and fresh as your clothes. To keep
washer interior odor-free, follow this recommended monthly
cleaning procedure:
1=
2.
Make sure the washer is empty.
Using recommended AFFRESH ® washer cleaner, add one
tablet to washer drum.
OR
If using liquid chlorine bleach, add 1 cup (250 mL) to liquid
chlorine bleach dispenser.
\
iMPORTANT: Do not add detergent to CLEAN WASHER
with AFFRESH
TM
cycle. Do not use more than recommended
amount of bleach to avoid damaging product over time.
3. Close washer lid.
4. Press POWER.
5. Select CLEAN WASHER with AFFRESH
TM
cycle.
6. Press START/PAUSE/UNLOCK.
NOTE: For best results, do not interrupt cycle. If cycle must
be interrupted, press POWER/CANCEL and run a Rinse
& Spin cycle to ensure cleaner or bleach have been rinsed
from washer.
To clean exterior:
1. Use a soft, damp cloth or sponge to wipe up any spills.
2. Use all-purpose surface cleaner, if needed.
iMPORTANT: To avoid damaging the washer's finish, do not
use abrasive products.
NON=USE AND VACATION CARE
Operate your washer only when you are home. If moving, or
not using your washer for a period of time, follow these steps:
1. Unplug or disconnect power to washer.
2. Turn off water supply to washer, to avoid flooding due to
water pressure surge.
f
1.
2.
3.
4=
5.
6.
7.
TRANSPORTING YOUR WASHER
Shut off both water faucets. Disconnect and drain water
inlet hoses.
If washer will be moved during freezing weather, follow
WINTER STORAGE CARE directions before moving.
Disconnect drain from drain system and drain any
remaining water into a pan or bucket. Disconnect drain
hose from back of washer.
Unplug power cord.
Place inlet hoses and drain hose inside washer basket.
Drape power cord over edge and into washer basket.
Place packing tray from original shipping materials back
inside washer. If you do not have packing tray, place heavy
blankets or towels into basket opening. Close lid and place
tape over lid and down front of washer. Keep lid taped until
washer is placed in new location.
r
RE! NSTALLING/USI NG WASHER AGAI N
To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to "Installation Instructions" to locate, level, and
connect washer.
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong,
Do not use an adapter.
Do not use an extension cord,
Failure to follow these instructions can result in death,
fire, or electrical shock.
WINTER STORAGE CARE
IMPORTANT: To avoid damage, install and store washer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer. If storing or moving
during freezing weather, winterize your washer.
To winterize washer:
1. Shut off both water faucets, disconnect and drain water
inlet hoses.
2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run
washer on RINSE & SPIN cycle for about 30 seconds
to mix antifreeze and remaining water.
3. Unplug washer or disconnect power.
2.
3.
Plug in washer or reconnect power.
Run washer through BULKY cycle to clean washer and
remove antifreeze, if used. Use only HE High Efficiency
detergent. Use half the manufacturer's recommended
amount for a medium-size load.
9