Maytag MVWX500XL2 Use And Care Manual page 12

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/help
for assistance and to posNbly avoid a service call.
Washer not draining/
spinning, loads are
still wet (cont.)
Wrong or too much detergent
causing suds to slow or stop
draining and spinning.
Dry spots on load High speed spins extract more
after cycle moisture than tradNonN topqoad
washers.
Check for proper water supply. Incorrect or wrong
wash or rinse
temperatures
Energy-saving controlled
wash temperatures.
Load not rinsed Check for proper water supply.
Not using HE detergent or
using too much HE detergent.
Washer not loaded
as recommended.
Sand, pet hair, lint, Heavy sand, pet hair, lint, and
etc. on load after detergent or bleach residues
washing may require additional rinsing.
Load is tangling Washer not loaded
as recommended.
Not cleaning or Wash load not completely
removing stains covered in water.
Added more water to washer.
Washer not loaded properly.
Use only HE detergent. Always measure and follow detergent directions
for your load. To remove extra suds, select RINSE & SPIN. Do not add
detergent.
The high spin speeds combined with air flow during the finn spin can
cause items near the top of the load to develop dry spots during the
final spin. This is normal.
Make sure hot and cold inlet hoses are not reversed.
Both hoses must be attached to both washer and faucet, and have
both hot and cold water flowing to inlet valve.
Check that inlet valve screens are not clogged.
Remove any kinks in hoses.
Energy Star _ qualified washers use cooler wash and rinse water
temperatures than traditional topqoad washers. This includes cooler
hot and warm washes.
Make sure hot and cold inlet hoses are not reversed.
Both hoses must be attached and have water flowing to the inlet valve.
Both hot and cold water faucets must be on.
Inlet valve screens on washer may be clogged.
Remove any kinks in the inlet hose.
The suds from regular detergent can keep washer from operating
correctly.
Use only HE detergent. Be sure to measure correctly.
Always measure detergent and follow detergent directions based on
load size and soil level.
The washer is less efficient at rinsing when load is tightly packed.
Load garments in loose heaps evenly around the washplate. Do not
load garments directly over the center of the washplate.
Use cycle designed for the fabrics being washed.
Add only 1 or 2 additional garments after washer has started.
Add an Extra Rinse to the selected cycle.
See "Using Your Washer" section.
Select a cycle with a slower wash action and spin speed; however,
items will be wetter than those using a higher speed spin. See the
"Cycle Guide" to match your load with the best cycle.
Load garments in loose heaps evenly around the washplate. Do not
load garments directly over the center of the washplate.
Reduce tangling by mixing types of load items. Use the recommended
cycle for the type of garments being washed.
Washer senses load size and adds correct amount of water. This is
normal and necessary for clothes to move.
Do not add more water to washer. Adding water lifts the garments off
the washplate, resulting in less effective cleaning.
Washer is less efficient at cleaning when load is tightly packed.
Load garments in loose heaps evenly around the washplate. Do not
load garments directly over the center of the washplate.
Add only 1 or 2 additional garments after washer has started.
J
12