Option Selections; Controls And Cycle Status - Maytag MDB4709PAB0 User Instructions

OPTIONS DISH LOAD TYPES DESCRIPTIONS USE WITH: ADDED
TIME TO
CYCLE
Tough food s0 S Adds heat and wash t me to the cyc e JetCeanPusSteam, Norma, 5mn.
I and Auto Clean I
tou_h
• , , ,
Tough food soils Increases the target water Jet Clean Plus Steam, Normal, 10 rain.
,m temperature during the wash portions and Auto Clean
hi temp Iw=sh of the cycle. Adds heat, time, and
water.
I AII!0ads ' Use for best drying results in Jet Clean Plus Steam, N0rmal, 25 min,
combination with rinse aid, Turn off Light, Quick Wash and Auto Clean
"°=°_ When cads conta n past c
cjihnn;;wa:re ;[qat mdayl b _ tsienstiie t0
. higher temperatures,
steam
Isanitize
To sanitize your dishes Raises the water temperature in the Jet Clean Plus Steam, Normal, 30 min.
and glassware final rinse to approximately 154°F and Auto Clean
(68°C). This high temperature rinse
sanitizes your dishes and glassware
in accordance with NSF/ANSl
Standard 184 for Residential
Dishwashers. Certified residential
dishwashers are not intended for
licensed food establishments.The
Sanitize option adds heat and time to
the cycle.
DelaYs the start Of a CYc!e up to Ai! cYc!es 2;
8 hours. ' hours
All loads When Control Lock is lit, all buttons All cycles
are disabled. If you press any pad
while your dishwasher is locked, the
light flashes. The door can be opened
while the controls are locked.
CONTROLS AND CYCLE STATUS
CONTROL PURPOSE COMMENTS
To start or iesume a If the door is opened during a cYcle or the power is interrupted, the START/RESUME
wash cycle indicator f!ashes. The cycle wi! I not resume until the door is closed and START/RESUME is
pressed.
NOTE" If the START/RESUME button is located ontop of door, push door firm!y closed
within 3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds,
the start button LED will flash, an audible tone wi!! be heard (on som e models), and the
i
cYClewill not start,
To reset any cycle or
options during
selection.
To cancel a wash
cycle after it's
started.
Press CANCEL/DRAIN to reset any control selections made.
See "Canceling A Cycle" and "Changing a Cycle After Dishwasher Is Started" sections.
To turn the audible Press and hold the Hi Temp Wash button for3 Seconds to turn the audible tones on or off.
,,= tones on or off. Only audible tones for confirming button presses can be turned on/off, Important audible
hi temp
Iw=,, tones, such as indicating a cycle has been interrupted, cannot be deactivated, (Not
available on all models.)