Table of Contents
Advertisement
@°°_e
of connector : D-Sub _pin male
Pinname
1
2
3
4
5
6
7
8
9
No conned:ion
RXD
(Receive
data)
TXD (Transmit
da_3)
DTR (DTE side ready)
GND
DSR
(DCE side ready)
RTS (Ready
to send)
CTS (Clear
to send)
No Connection
1
5
@
000 '
@
6
* Use a null modem cable
Wire the 7-Wire cable so that each pair of data lines cross between
the bt¢o devices.
These data line pairs
are RXD (Receive
data) and TXD (Transmit
data), DTR (DTE side ready) and DSR (DCE side ready), and
RTS (Ready
to send) and CTS (Clear to send).
When using the 3oWire cable conn_t_
to RXD, TXD and GND; Pin No. 4 (DTR) and Pin No 6 (DSR)
must be connected
to the monitor.
(The cable must be disconnected
from the Monitor
to be able to use the
remote controt and Monitor
front panel controls.)
, With the RS-232 input connected,
the Monitor
cannot be controtl_
by both an external control device
and
the remote control at the same time. The Monitor
can only be controlled
by either the remote control or the
external control device.
48
Advertisement
Table of Contents
