Table of Contents
Advertisement
up
- You can easily connect the Plasma Display to your PC for outstanding image and sound.
Use the Monitor to display images and:sound from a PC Computer source.
Setup Instructions to Connect a PC to your Monitor
• If the image output of the PC is set higher than
UXGA, no picture will appear on the Monitor.
(UXGA is not supported.)
• Connect
the signal cable from the monitor Output
port on the PC to the RGB-PC
INPUT
(VGAiSVGA/XGA/SXGA)
port on the Monitor.
• Connect
the audio cable from the PC to the Audio
ports of the Monitor_ (Audio cables
are not supplied
with the Monitor.)
° To set up the Monitor
to operate within a PC win°
dows environment,
select Norma_, Standard
or
o
J
Default monitor:
The Monitor can not be us_
for Plug and Play
functionality.
If your PC computer
is equipped
with a sound card,
adjust the sound output on the PC.
It is recommended
that the resolution
output of the
PC should
be set to t280
x 720 to get the best
quality picture,
(Look for a video card that uses the
nV_D_A GeForce
2 pro or similar chipset that
supports
this resolution)
Back panel of the Monitor
video/_
Ot_ the remote control
PC Setup
. First, turn on the PC computer
and press the ON/OFF
button on the
Monitor to apply power to it. Second,
turn on the display
by pressing
the (b/_ button on the Monitor or by pressing
the POWER
button on
the Monitor's
remote control,
° Use the
video/pc
button on the remote control to select the RGB
input source.
, Set the resolution output of the PC to SXGA or under (1280 x 1024,
75Hz). (Refer to page 21 .)
2O
• Avoid keeping
a fixed image on the MonitoCs screen for a long period of time. The fixed image may
become
permanently
imprinted
on the screen; use a screen
saver when possible.
• If the resolution
output of the PC computer
is over SVGA, connect
the PC to the RGB-PC
(VGA/SVGA_XGA!SXGA)
input port on the Monitor.
Change the PC computer
resolution
output
accordingly.
Advertisement
Table of Contents
