LG LP090HSD-Y8 Owner's Manual page 20

Control Locations
- Before the following disassembly, POWER SWITCH is set to OFF and disconnected the power
cord.
1. Remove the front grille.
2. To remove the front grille, pull out the bottom of
the front grille and then lift up.
Re-install the component by referring to the
removal procedure.
3. To replace the front grille, place the tabs over
the top of the unit and push the bottom of front
grille until the clips snap into place.
• This Room Air Conditioner (PTAC) discharges
air from the top of the unit through reversible, 2-
position discharge grille louvers. The unit is
shipped from the factory with the discharge grille
louvers at an angle of 40 ° off vertical. In an
alternate position the louvers will be at an angle
of 15 ° off vertical.
40 °
15 °
Screws
To adjust the air direction, remove the front grille.
Remove the 4 screws that fasten the discharge
grille to the front grille.
Flip the discharge grille 180 °, then reattach the
discharge grille to the front grille with 4 screws.
20 Room Air Conditioner