Leveling The Ice Maker; Reversing The Door Swing - NORPOLE EWCIM44ST User Manual

Leveling the ice maker
tt is important for the ice maker to be leveled in order
to work properly. Otherwise water will not flow
properly through the evaporator (ice mold). The
ice production will be less than normal, and may
be noisy. The unit can be raised or lowered by rotating
the plastic sheaths around each of the four rolling
casters on the bottom of the machine. If you
find that the sur[hce is not leve!, rotate the casters
until the ice maker becomes level. You may need
to make several adjustments to level it. We
reconmaend using a carpenter's level to check
the machine.
// -L_ -L /
up
/down
/
1. Place a calpenter's level on top of the unit to see if the ice maker is level from fiont to
back and side to side.
2. Adjust the height of the casters as follows:
Turn the leveling casters to the right to lower that side of the ice maker.
Turn the leveling casters to the left to raise that side of the ice maker.
You will find that the casters make it easy for one person to move the machine. This is
useful for cleaning and sanitizing the surface on which the ice maker is installed because it
al!ows you to move the unit and have easy access to the surface to be cleaned.
IMPORZ4NT. Ilqwn the ice maker is' ready to be installed in a cabinet or direct@ on the
flora; 3'ou must adjust the feet to level the ice maker and lock the rollers. If the Jloor is
level, just revoh'e the twoji'ontjeet to touch the floot:
Reversing the door swhtg
Tools needed: flathead screwdriver: Phillips screwdriver
IMPORTANT: Before )'ou begin, unplug the ice maker or disconnect powel:
To remove door from hinges:
l. Remove the top hinge cover.
2. Using a Phillips screwdriver, remove the screws, then remove the top hinge mat and
top hinge. Keep the parts together and set them aside.
3. Lift the door offofthe bottom hinge and set the door aside.
To replace door on hinges:
l. Using a flathead screwdriver, remove the plug buttons from the screw holes opposite the
door hinges, top and bottom. Set aside.
2. Remove the fiont louver. Set aside.
3. Remove the bottom hinge and place it on the opposite side at the bottom of the door.
l o