Advertisement
ToEngageDrive
1.
With the throttle
control
in the Fast (rabbit)
position,
move
shift lever into one of the six forward
(F) positions
or two
reverse (R) positions.
Select a speed appropriate
for the
snow conditions
and a pace you're comfortable
with.
2.
Squeeze the drive control
against
the handle the snow
thrower
will move. Release it and drive motion
will stop.
ToEngageAugers
1.
To engage the augers and start throwing
snow, squeeze
the auger control
against
the left handle. Release to stop
the augers.
Replacing ShearPins
The augers are secured to the spiral shaft with two shear pins
and cotter
pins. If the auger should strike a foreign
object or ice
jam, the snow thrower
is designed
so that the pins may shear. If
the augers will not turn, check to see if the pins have sheared.
See Fig. 5-1.
CAUTION:
NEVER replace the auger shear pins with
anything
other than OEM Part No,738-04124A
replacement
shear pins. Any damage
to the auger
gearbox
or other components
as a result of failing
to
do so will NOT be covered
by your snow thrower's
war ranty,
WARNING!
Always turn off the snow thrower's
engine
and remove
the key prior to replacing
shear
pins.
Figure 5-1
SECTION
S --
OPERATION
15
Advertisement
