Dell Studio One 19 Service Manual page 43

1 heat sink captive screws (2)
3 system fan cable
10. Lift the assembly away from the system board and place it in a secure location.
Replacing the System Fan and Heat Sink Assembly
1. Follow the procedures in Before You
2. To replace the system fan and heat sink assembly, connect the system fan cable to the connector (SYS_FAN1) on the system board.
3. Tighten the two captive screws securing the heat sink to the system board.
4. Replace the three screws securing the system fan to the system board.
5. Replace the back I/O panel (see
6. Replace the stand (see Replacing the
7. Replace the shield (see Replacing the
8. Replace the computer cover (see
Back to Contents Page
2 system fan screws (3)
Begin.
Replacing the Back I/O Panel).
Stand).
Shield).
Replacing the Computer Cover).